开云体育

Hi Tony, i've only just started using shortcuts and they could be very handle. Shortcuts works like a command list or schedule list. A Shortcut can also adds a icon on the iphone home page. Basically

100%. https://support.crestron.com/app/answers/detail/a_id/1000489#Programs Toolbox automatically zips the .sig file to a .zig during program upload; you have to do that manually and push the .zig to

I'm not sure about a DM-MD8x8 but I know in a DMPS3 you can pass telnet through the DMPS3 to the endpoint on certain ports. Try doing a DUMPDMIPCONFIG on the 8x8 and see if it gives you a table that

Yes, this works. The action you want is "Show Remote Control".

Back in the early days of the DM-MD8x8, there were no private addresses for the DM endpoints.? Instead everything was on the same subnet as the DM chassis.? Later firmware allowed you to switch to a

Of course I'm assuming this isn't a client, you could use a new processor in that case, I just assume you're going via tcp commands for some kind of lab/personal thing. [email protected]> wrote:

For something like this I would probably just rack up an old mp2e from ebay. You can enable external network mode on the switcher to give it an ip, I'm not sure if there's a documented telnet protocol

I'm building an external control system that will send simple commands to a Crestron DM using TCP (telnet) commands.? This works fine with the DM-MD8x8.? But I'm not sure how to switch inputs on the

Thanks for the explanation, Alex!

Has anyone seen this error, and did you resolve the issue? Contacted TB and wasn't able to resolve but sent them all my code for testing. Error 1706 (Line 52) - Error including SIMPL# Library:

Just an update.? I finished a job this week controlling the Genie 2 clients.? I am using the Controlworks module.? The Genie itself get an IP and clients only have a MAC address.

Alex, Does this still work with the ATV remote now that it is relegated to the Control Center??

Unfortunately, that command only works when you have Authentication turned on...

Take a look at answer ID 1000489. Moderated: Edited to remove content that isn't publicly available.

Also for the CH integration you will need a Lutron Connect Bridge in place.

You'll need an integration username/password and the integration report. This give you the mapping between loads/buttons and the ID numbers to use in the modules. If you're using CH, you just need the

When loading .lpz with filezilla, where does the .sig file get loaded? I tried putting it in the same folder but when i open debugger it says no file found

I'm working with an installed Lutron Radio RA system.? Lutron is currently being controlled by Control4 that was installed several years back by a C4 dealer.? C4 system will be removed and replaced

Something about Console, SETLOGOFFIDLETIME 0 ? From: <[email protected]> on behalf of ckangis <chris@...> Reply-To: <[email protected]> Date: Wednesday, May 25, 2022 at 2:34 PM To:

I've been running it since last year and it's been the best experience I've ever had with a laptop. For doing things with S# I have had to make sure that I reinstall/repair: NETCFSetupv35