开云体育

Control Concepts http://www.controlconcepts.net

Thanks for the responses, No i have no backup, i?m not shure if the programmer used crosspoints but it seems like, cause of the naming in the debugger. The RoomButtons triggers Signals like

Ok great thanks Thanks , Mingo

The WHEN avoids this problem since it’s a pulsed trigger at a specified time rather than the PAST’s latched output. -- Lincoln King-Cliby, CTS, DMC-E-4K/T/D Commercial Market Director Sr. Systems

Lol ? ok thanks for the advice Thanks , Mingo

"Clock Driver -> PAST(03:00:00:00s in parameter) -> One Shot-> Button presser-> Projector Power OFF" Be sure to keep in mind - if you load code after 3AM, the projector is going to turn off

Ok thanks Thanks , Mingo

These guys have an email module with TLS, so maybe they'd be able to help get you pointed in the right direction? I haven't had to do TLS myself, fortunately.

Pretty sure the error message says to leave the DST blank, because you set it on the processor. Crestron@...> wrote:

use clock3 symbol clock with no dst parameters Sent from my Samsung Galaxy smartphone.

Leave it at 0d. It will pull dst from the processors clock settings Ryan Gray 480-277-7012

What should I set the dst for the clock driver ? It’s a 3 series processor and it’s giving me an error when I set it to 1d Thanks , Mingo

Easiest method Clock Driver -> PAST(03:00:00:00s in parameter) -> One Shot-> Button presser-> Projector Power OFF I tend to use the Alarm Clock Module so the time is user editable.

WHEN would do the job

Guys I’m looking to see what symbol I should use for this ? The client wants me to set up a command to send an off command to a projector everyday at 3am Please help Thx

That's correct..

The other thought I had would be ARAM values weren’t moved over to the new CP3, so if they were using something that’s not set now it could cause an issue. Easy enough to get it and write it to

"If you took the code from the old CP3 and loaded it to the new one then in theory it should work the same." Unless there was something like a "config.txt" type file that had settings in it that were

Also, it could be a firmware revision issue, especially if the old CP3 hasn't been touched in a while. Crestron@...> wrote:

Yup its now in the device discovery tool. There’s a radio button at the bottom to select between local and remote. When you choose remote the connection buttons show up at the bottom of the window