开云体育

I discovered that too the hard way - each compile seems to increment the contract ID. What a pain!

Thanks - that seemed to be the issue. Contracts it is, then!

Downgrade to a version where forced auth mode wasn't a thing, disable auth/SSL, upgrade again.

Hello, anyone know of a way to disable AUTH or SSL so the legacy crestron mobile app works on FW 1.603 and above?

Go to the Poly support website. Look for video conferencing, select the camera, download the Poly Camera Control App on the MTR and it will automatically add the Room Controls page

As far as I know, this is done by the Poly Camera Control App https://m.youtube.com/watch?v=1xIW89-95HM

I just stumbled upon something. I'm installing two new rooms with FLEX MTRs in a big building. On the same network I discovered another UC-Engine installed by another company that has a custom page

Thank you both!

We recently have had two TSR-310s that starting to continuously reboot.? Again just out of the warranty period too.? Both sent to Crestron for repair and both turned out to have bad compact flash

I wish there were a way to run multiple Lutron instances in CH. I have a RadioRa3 and Caseta system but can only add the Ra system. Anyone know a work around?

I have seen this before and we mostly use Autonomic. Many times rebooting the MMS fixes the issue for us- havent really tried processor as its quicker and less disruptive to reboot the MMS. So I'm not

Go ahead, it works. Already tested and worked. NFH

We have used the TSR-310 remotes almost exclusively with Crestron Home (unfortunately, would like to do more custom work) and more often than not performance is horrible. We've had three of them now

I'm looking for some advice about connecting Lutron Caseta switches and keypads to a Crestron Home system.? Does the Lutron Smart Bridge integrate seamlessly to Crestron home in the same way as

As a follow up.? I purchased a TSR-310 connected to Crestron Home.? I've been using it for about a week and it has performed really well.? It's running the latest firmware and connected to my 5ghz

Thanks for the help! That was a perfect solution! I was looking for a single extender just for those sensors, and a name like Occupance_Sensor... Glad to know it is possible and people will point you

I think the Cresnet port -IS- available on a 3-series processor in Slave mode.? Answer ID 5232 describes it, and I'm fairly certain I've done it before.

Trash the OOTB, unless you like the scrolling lists of doom.? I set up many of these just fine with a basic simpl program, a few idiosyncrasies to deal with, but solid if you don't ask them to do too

EISC for sure.? I'd put only my button presses and feedback to the CP3, and do any lighting logic local to the mc3. I'm not sure you can use an eslave device's gateway, I know you can't use it as a

yep that was it. thank you!