开云体育

yes, but phone won't run 32-bit apps - see my other post about app not compatible crestron app for android is 32-bit i have asked what the state of Crestron Go (64-bit maybe) for android is, but for

we have a job from 2021, same code, reconnects quickly this job (compiled with newer libraries) is really slow this job is iOS

Thanks Brian.? I've never used CEC with NVX or DM.? Typically I hadn't found it to be as reliable and ran the risk of other devices triggering commands back thru (ie Blu-ray turning a display back

It shouldn't take nearly that long. Even on "slow" projects, I've never seen it take more than 5 or so seconds to connect. I suspect an issue with the device itself (some type of setting), the

Can't you just download the .apk file to your device and side-load the app?? That bypasses the Play store.

Good to know!! Just to clarify, My concern with P+H is not for example the recent ATV OS issue where you need two commands (Press and P+H) on the same button. My concern is when you need a repeating

is there anything i can do from a programming perspective to keep the app alive on the phone? maybe some sort of keep alive or heartbeat signal client is really unhappy with how long it takes to wake

TBH, have done quite a few of these guys and never run into a P&H issue, but it makes sense.? All the projects we have dealt with usually feed TV audio back into distribution so its always just a

Jonathan, We are typically communicating to displays with Crestron products like DM or NVX, so never had any problems there. However, Crestron makes an HDMI display controller specifically for the

I feel a bit stupid asking, but to control a CEC display I need to have a "driver" that allows me to insert control commands onto the HDMI correct? Is there another port on any displays that can be

Hi All, We're doing are first MXnet project (finally!) and we're needing to use it to pass IR to devices. I'm confident of the process with the v2.x modules. My question is what is the experience with

Anyone make a better module for the response amp other than what's posted on the snap website?

Below are notes I send to technicians, with the settings needed for LG ethernet communications. You've obviously taken care of #1, but I'd double-check the others. Typically when Power On (only)

This is probably too simple, but why not include the network and power cable in the cable routine? If you are moving some cables from one to the other, what difference does it make if you move a

Maybe programatically disconnect the TCP/IP clients from the secondary processor when the primary processor is detected as "ONLINE", and drive the secondary TCP/IP connection states high when the

Hi Joachim, thanks for the information. I was hoping not to have to dive into the details of the API of the TVs as there?s a driver available. I think i?ll go for the WoL for the power-on and then

Thanks for the recommendation. I’ll do some testing on that.

Hello Thorsten, do you have the API/Command-Specs for this device? If yes, you can do following: rename the pkg into a zip-file, unzip it. Inside there is the dll. Use a de-compiler, like JetBrains

OK, will do that, thanks. Cheers, Thorsten -----Ursprüngliche Nachricht----- Von: [email protected] <[email protected]> Im Auftrag von rickwookie Gesendet: Donnerstag, 16. November 2023 14:01 An:

I found the Power On would work about 10% of the time (as in 1 in 20 triggers). Send a simple WoL packet to the TVs MAC address (use the UDP symbol) and it fires every time. It annoys me that the CCD