开云体育

Hm, unfortunately, i can?t say much more than this is how it should work… I?m using a \x0D at the end of the commands. Sending a “QSTATVER\x0D” should get you a response. Cheers, Thorsten Von:

I?d give IRUSB a try. It?s more aimed towards Android based media player boxes, but it should work on any Android based device with a supported USB port. Cheers, Thorsten

I tried with a Crestron certified programmer this whole morning to try to get it work, it doesn't... very frustrating. Whatever commands we sent has no response from the TV. Lost, don't know what to

Hey guys, I'm just tinkering around with an NVIDIA Shield Pro & the IRUSB device+app and having some issues. I cant seem to get any of the QHIDCODE's to work which is a bit weird! I've tested it with

I feel so much better with more people not looking at the date on the OP... : o

Or, you can use a good 'ol ST-VS in there, and do sync detection off the composite video feed to determine the true state of power of the VCR, so when you send it the "power toggle" command, you have

Sounds like they are trying to purchase rather than download previously purchased apps. ? ? Was it Go or Crestron for X that was previously purchased? ? ?Get them to go to the app store and click

It's been awhile since I've had to do this... have a customer with a new iPhone and they have re-downloaded the Crestron Go App. They have already purchased the App on the Apple ID in question. It's

Bah!? Got me not looking at dates and bumps!

So was the thread's original email.

Shesh, that equipment is probably older than some of the programmers on this site.

I dont, never have nor ever would use system builder but I know from past experience troubleshooting the code of others that have used it that it populates every signal on every device. This is the

When we used to do this type of thing System Builder didn't exist. I've been programming Crestron systems for over 20 years, though I'm happy to say I'm 90% retired these days, I just pop by here once

Did you porgram this in Simpl or with System Builder or something? If you used Simpl, this sort of thing wouldnt happen unless you programmed it to do so. What else is in your system?

That is some old school stuff that probably requires some old school programming. Back in the CNMSX era most AV gear didn't have discreet power codes, The solution was to use the play command to turn

Crestron uses the term " *Recovery Procedure* " when referring to resetting a device (to "fresh out-of-the-box state" or "factory defaults") when credentials need to be cleared or there are issues

Start by reviewing the streaming device settings. Typically (if possible) you'll want to set up a new substream with very low settings (480p@10fps, etc.) to test with, then gradually increase its

how do you reset the crestron nvx 360 because the power light is orange

Guys, were you able to control it? I have a collage just asking for this exact thing and he is not being able to control the tv with the described api. TV is responding to pings, so it's alive. Thanks

First thing that comes to mind - is your camera stream h265? If it is, that will be decoded on x70 but not on older panels like the 902. If it is h264 or MJPEG, lower res/refresh/bitrate till 902