开云体育

Since this is not S# Pro, you might consider just checking for control system type in the S+ wrapper and passing it back. /* Global Variables */ INTEGER SystemType; /* Main() */ Function Main() {

The following files have been uploaded to the Files area of the [email protected] group. * /Switch-Buffer.zip ( /g/crestron/files/Switch-Buffer.zip ) *By:* mark@...

The following files have been uploaded to the Files area of the [email protected] group. * /StringToXMLSorted v4.zip ( /g/crestron/files/StringToXMLSorted%20v4.zip ) *By:*

I'm not certain what is going wrong with your content length header, however I wanted to share how I was handling the headers in a different way than your code. Perhaps it will be helpful to you. This

To clarify just a bit... Event Scheduler v1.2.0 dates back to 2-Series, before 10 program slots were available. So for 2-Series \\NVRAM\\scheduler.dat in SIMPL simply refers to \NVRAM\Scheduler.dat.

In this case, yes. Update: I have got that command down now and am able to switch as needed now.

If the OP were trying to process the entire string or if there was more variability in the strings I would agree but it seems for what they want/need it could be done in an SIO, for example: Parameter

There are ways to extract and match strings in SIMPL, especially if they are fixed length or if there is a fixed pattern, which your strings appear to have. However, the string example you present

Hi, I was wondering what the best way in SIMPL was to extract part of a return string to enable another digital signal. for example: my return varies between states like below: I need to extract; say

Thank you

Sonos is only the tip of the iceberg in regards to bloating the logs...It would at least be great if someone actually knew what half the entries meant??

I guess you are using a non-crestron control system?

Tray, I didn't write the Crestron module but we did write drivers for other platforms and they way you are sending the strings pretty closely matches our drivers. We are definitely sending the quotes

Does anyone have a list of console commands for this device? All I really need is the command to switch between HDMI input 1 and input 2 as the transmit source, but any commands available would be

I have found out that it is possible to power the CSM-QMTDC-163-1-EX motor with a battery pack.? This is not supported by Crestron but it can be done.? The motor draws approximately one watt in

I am here having an issue with the HttpsClient. The request runs into an "unknown error" whenever I try to add Content-Length to the header. It runs fine otherwise. About the sample code below: you

Hi Shawn Yes do have the protocall commands in PDF. I was hoping someone had a module built up allready. Did not find what I was looking for on the crestron market place except the basic commands like

Same here.? Been solid for my work.

Have you used MDC before? If not I can get you started as I have all of the basic commands like On/Off, source selection, Volume up down, Brightness up down, mute. Do you have the MDC protocol PDF

Is there any way to stop these stupid messages appearing in the logs from Sonos. Debug is off. Really Crestron - just give us error msgs if something is broken. Do I really need my processor SD card