开云体育

Hi Group, I need to control some shades and lights from a Lutron QS system. I'm using a CP4 with the QS r04 modules and from what I understand you can no longer use telnet on 4-series processors. My

Don't think I've done one with Crestron but from Q-SYS iirc it's just VISCA (with presets 80 and 81 to enable and disable tracking). -- any of the Sony EVI-Dxxx 1-way serial with the extra presets on

What module do you guys recommend to control this camera ( Aver PTZ310N) via RS232? Thank you

/g/crestron/files/Modules/HaikuFan%20v2.1.umc

In boot settings, is WOL On? Sounds like the unit goes to sleep and won't wake up. We had a similar issue with (8) NEC 90" monitors in a classroom. Not all of them would turn on and it seemed to be

The AMP-2210HT is our go to amp here at the university where I work. We have them in more than a dozen rooms in both 4/8 ohm configurations and 70 volt. The sound is just fine. We only had one issue

Hi, Can you let me know your email address or you can send me an email on rajiv.jain at synapsetech dot io <jarlehenriksen@...> wrote: Rajiv Jain

Exactly what I do. I use both protocols. No problem. I’ve written my own module in simpl# for the http protocol. Over time I may add the transport and volume control etc in to the simpl# module

Well after reading your answers I realised that both modules don't use the same protocol on TV but if both co-exists without problem it's fine ;) Will go this way, thanks for help ;)

I'm interested in testing your module ! My test Pro# has MAC: 00:10:7F:3D:28:F0 Thanks in advance. Jarle

We have a module developed for Android Sony TV. You can recall apps and they appear as as when you download live on the TV. Please send us the MAC ID of the processor and we can send you a

Yes I agree. But you can’t add the commands to directly launch apps ( other than Netflix which has an IR Command) To directly launch other apps you need to send commands via http requests. That

Hi ! I'm using the Sony 2014 Bravia module from the app. market. It's easy to add commands to the module, particularly in the IR emulation section. The IR commands for new functions are well

Any compilation errors are likely the result of your code (or the packages you're using, if any). -- Crestron Service Provider - TBD Enterprises Inc.

This is correct, particularly if the device is (a) not at 9600 and (b) you’re using he device extender to set the baud rate – if the device goes offline, unless you’re careful with your

Thank you all. I asked on Facebook also and one person on there had an issue with the baud rate changing. Which could make sense. we are going to take a laptop and puTTy and check the baud rate the

This makes no sense. If you are getting back command with a loopback - it should work. If the cmd string is correct, the only other variable would be somehow baudrate drifted (RMC 233 voltage issue is

I don’t know of such any module that will do everything in one. I use one of the simple ip control modules that is in the marketplace to control most functions. I also use a module that I’ve

Hi Looking to control some Sony Bravia (Android based) but can't find a module that allows full control of it :( I mean control all basics functions including tuner but also recall apps into it. I

Been a little busy so not had time to try this until the other day. ? I found using the SIMPL module there was no volume level feedback from the Sony when the headphone socket is in use. ? Remove