开云体育

I dont see any way to get any of the Xpanels or Crestron Mobile to open the Core3UI designer in Studio. Am I missing something? I made a new project with a cp2e (what I have on hand) added an Xpanel,

Where do you insert a user name and password into this string? TIA, Craig

If i short tx & rx on display end, i get my command returned in the debugger.

But now you need a magnifying glass to read your screen. :-)

SO I am having issues talking to a Lutron processor via crestron. I have the lutron program and i have set the rs232 ports as follows baud rate 9600 data bits 8 stop bits 1 parity N Handshaking is on

Curious if anyone else is having issues with file manager recently. The folders are shown in the main view, not the tree view, and you cannot place anything in the folders. This on a QM-RMC, worked

The power on/off commands and comspec you've posted appear correct. Not exactly sure why you're not getting better results? I'm not sure whether or not a null modem cable is correct or not, but the

Of course, thank you both.

Ring counter.

Ring counter [Non-text portions of this message have been removed]

Can't blame ya' for that... :) - Chip

Hi, Sure this is a simple one but getting tired now... What would be the simplest way to round robin from a button press? Press once -> Output 1 Press again -> Output 2 Press again -> Output 3 Press

Hi Guys, I am trying to control this tv via rs232 but the only reply i get back from the unit is FF and it refuses to either turn on or off. I have the TV ID set to 01 and using the crestron module. I

I have about 20 of these keypad/dimmers in my house. My advice is do not try to use them for volume. Mine will work fine for weeks, then they will do exactly what you describe, for a little while,

It's true. You're paying for their servers to manage and administer the thing, when you stop paying it stops working. Nothing unusual about that, it just doesn't typically apply to network hardware.

It locks high (remember, these are acting as buttons, I am using only button 1 to control the dimmer). As for the solution, we are thinking alike, here is what I have tried so far. 1. just as you

Locked on as in ramps to the moon, or just feedback stuck on? and stuck for good or just for a few seconds? If the latter you could use some logic to slow down the feedback maybe init, debounce, equ,

I hope I am wrong, but I was specifically told by them that once the support ran out there was no way to configure the equipment, and they would stop passing traffic. This was two sales engineers from

File Manager in Toolbox From: avninjacolorado <rebkhai@...> Reply-To: <Crestron@...> Date: Wednesday, April 10, 2013 2:27 PM To: <Crestron@...> Subject: [Crestron] Re:

Does anyone use the Signal Level inputs on the amp? How often do the values update? Chris