Re: DM Private Mode Pros/Cons
|
There are several ways you could accomplish that depending on the network configuration and topology.? The two obvious methods to me would be:
1. VLAN tagging by MAC at the switch 2. setting each NIC on the DPMS up with different settings if they're on a flat network
On Wed, Jun 25, 2014 at 4:46 PM, Martin Kupferman martin@... [Crestron] <Crestron@...> wrote:
?
How do you manage to put the processor and video board on different subnets, while they are on the same physical port?
?
we have a client who use different subnet for processor side and video board of the dmps 10.100.0.x. - processor
10.100.2.x - video 255.255.0.0 odd for building1 and even for building2 never have issue. {Paf} Mobile Le 25 juin 2014 10:51, " nick@... [Crestron]" < Crestron@...> a ¨¦crit :
?
Hi all,
I am gearing up for a university install of about 30 rooms. Each will have a DMPS-300-C. I know these use two IP addresses and that Crestron recommends PNM. What are the disadvantages of PNM other than having to go through the switcher to manage Tx's and Rx's??
I assume that if I use the LAN port on an endpoint (for a Projector), it connects to the same network that the DM switcher card is on, and not behind the NAT?
Does anyone find using different subnets for each room useful? For example: 192.168.11.xx for Room 1 192.168.12.xx for Room 2 etc.
This way, I can say that every DMPS-300-C is 192.168.xx.5 and so on.?
The classrooms are not connected to each other from an AV standpoint. But, I would like to be able to manage all of them simultaneously.?
Any other pointers?
|
