Re: Lutron QS Request Command <--Please someone help!!
|
thanks everyone!
toggle quoted message
Show quoted text
--- In Crestron@..., "floyd1212" <floyd1212@...> wrote:
It may work without the action specified, and default to action 1 on a query, but the protocol definitely shows the action being used with the query in their example.
--- In Crestron@..., "Siong P Low" <sp@> wrote:
I am not 100% certain on this, but am pretty sure that the query command is "?OUTPUT,1\n".
The Action number is only for actual commands:
For example, Action 1 is set output level
#OUTPUT,1,1,80,4,1\n - this will set unit ID 01 to 80%, 4 sec fade, 1 sec delay
#OUTPUT,1,2\n - will just raise the level of unit ID 01
... and so on.
The query command does not use the Action number, I believe.
--- In Crestron@..., "sevenstarokawari" <tabata@> wrote:
I am glad to get kind reply from you.
OK,,, i will try with "?OUTPUT,ALL_DEVICES,1"
Do you know what's the meaning of the last "1"
According to the manual, it says "Action Number"
I can't understand...
--- In Crestron@..., Eric Williams <ewilliams0305@> wrote:
Its been a while but instead of "1" try the commands using "ALL_DEVICES" as your integration Id. It will definitely work for polling not sure about setting levels.
-----Original Message-----
From: "sevenstarokawari" <tabata@>
Sent: ?€�3/?€�21/?€�2013 9:09 PM
To: "Crestron@..." <Crestron@...>
Subject: [Crestron] Re: Lutron QS Request Command <--Please someone help!!
--- In Crestron@..., "sevenstarokawari" <tabata@> wrote:
Would someone advise me the command to get all zone's brightness of Lutron QS simultaneously?
Actually I sent"?OUTPUT,1,1<CR><LF>", but nothing happens.
The Lutron QS ID of mine is "1"
Regards,
[Non-text portions of this message have been removed]
|
