开云体育

Thanks John, Will see what I can do to figure this out! Glenn

Hello I see a new version of pilinbpq in the Dowload/Beta directory: Where can I find instruction on how to perform upgrade to this version? Thanks 73, Heber NP4JN

What program are you using to transfer the data? Is this an upload or download? The Linux axcall will resume transfers (at least for downloads) Sent from ProtonMail mobile

Had same problem , turned off windows defender, and ran software. Ray N3HYM

Trying to install the Windows version of BPQ, v6.0.22.1_20210822.exe. Windows Defender marks this as critical and removes the file. I assume this is a false positive, any else have success with this?

Basically, my question is:? are errors like retries, out of sequence and REJ packets collected by the node stats during a YAPP transfer?? If not, is there a way to see this performance data? --

Do you have both the KISS and AGW interfaces enabled in SoundModem? If so there is the risk that both SoundModem and BPQ will respond to a connect request. So long as your users only ever connect to

WinmorControl (https://www.cantab.net/users/john.wiseman/Documents/WinmorControl.htm) can pass cat commands from BPQ Rigcontrol to a remote Windows machine. 73, John

Two ways RealVNC or MS remote if windows 10/11 pro [mstsc]... I assume rig-control is the cat controler.controller.. Herbert KD5PQJ

I am using LinBPQ and have 2 Windows 10 PC's running Soundmodem and VARA HF for packet forwarding and Winlink. IC-7300 connected to the Windows machine so that I can use the VARA software using CAT.

Success!? Looks like I spoke too soon with failure ;)? Here is what I did to get this to work (if anyone ever needs this): In the UZ7HO software for the HF TNC: Set to dual channel in

The config is the same for Soundmodem and QtSoundModem. 73, John

I have narrowed the issue down to the connect script and the ports configuration... If I change my CFG file to use all UZ7HO drivers (no KISS) and adjust the connect script to the below (where Port 2

I would like to run everything on pi, So I would to try your QT Southmodem. What is config for your QT Soudmodem on the pi? Installing you QTSoundModem; I will follow your website institutions; if I

From the documentation: Normally the system will make an L4 (NETROM) connect to a call that is in your NODES table. You can force a level 2 connect by specifying a port number and preceding the call

Hi all, I am running into a challenging issue with forwarding. I am trying to forward, at night, via RF to a station that is mapped in my AX/IP port definition and it's not working.? Here is what I

This really makes no sense. Could you send me the WX7RNO config and I'll try it here and see if I can find out what is going on. Thanks, John

It is a good point to raise. Max Message Number defines the point at which Housekeeping renumbers messages, starting from 1. It is not actually a hard limit, and the BBS won't crash. However it could

A normal UZ7HO port definition is PORT ?ID=UZ7HO ?DRIVER=UZ7HO ?CHANNEL=A ?INTERLOCK=4 ?PACLEN=100 ?CONFIG ? ADDR 127.0.0.1 8000 ? MAXSESSIONS=5 ? UPDATEMAP ENDPORT How are you running UZ7HO

Mike, WX7RNO and WA6MTY are both BPQ systems, I manage both of them.? WX7RNO is a radio only station with no direct internet connection, but it has an excellent antenna location and altitude