开云体育

Aha, there is certainly a network issue here. Lets see output of: traceroute rotate

NODEFAULTROUTE configured in IPGATEWAY section- no cfg errors on start- still no connect to APRS server. TELNET RESULTS FOR JOHN: APRS server connect via telnet result on Pi: root@Pi-BPQ:/home/pi#

Then configure it, is what I meant :-)

Can you try this from the Linux command line? telnet rotate.aprs.net 14580 I get this: Trying 192.104.234.220... Connected to rotate.aprs.net. Escape character is '^]'. # aprsc 2.1.14-g5e22b37 You may

Hi All mine is written in Upper & lowercase IGATE Params. ISHost= ISPort= ISPasscode= ISFilter= 73 Ken G7VJA GB7COW

Noticed ports defined in IPGATEWAY were 1 and 2 so I added 3 (APRS port) but still getting error. I then removed it since error persists. Port Driver ID Beacons Driver Window 1 BPQAXIP (

Also I noticed in my IPGATEWAY cfg there were references to old local ip addresses. I corrected those (44ENCAP and TAP lines specifically) and only change I see is that an? "APRS Igate connect

Thank you. "NODEFAULTROUTE" is not configured. The ENDPORT error was just a missed line that needed to be commented out from an unused port. Error cleared there. igate not connecting continues.

*bpq32.cfg line no 225 not recognised - Ignored: ENDPORT Heads up ^ *

This is just a hunch. The APRS connection may be trying to go out of the TAP device instead of your regular network. Make sure there is not a default route for non-AMPR traffic pointing to the TAP

Just tried the server you suggested. "ISHOST=noam.aprs2.net" Same error. Thank for the suggestion.

git clone git://vps1.g8bpq.net/QtSM should give you 0.0.0.63 (the latest) 73, John

This message is probably for John but if anyone can answer it would be great. I am experiencing a number of different versions of QTSoundmodem. The one in the source zip file seems to compile to

Hi All, Cheers for that, a silly misconfig by myself :) - I hope to be back in shack this evening to try it out. I set it to PMS to indicate there's no routing or anything going on i.e. You can only

Hi Red & Mike If Mat is running RF as well on his BPQ PMS, he can only run it unattended for 30 minutes maximum, after that he has to turn it off, (terms of his licence) because it is using RF. just

On Sun, May 14, 2023 at 04:20 PM, Mike Melnik wrote: > > Mat > > Don't use PMS twice, you may have your reasons for > using the Connection application as PMS but most > use BBS, Here is my Application

You can use a RADIO command in your BBS forwarding config to change frequency before connecting There are examples in https://www.cantab.net/users/john.wiseman/Documents/Forwarding.html At the moment

With a NODEALIAS of M5MPC connects to any ssid will go to the node. 73, John

Mat Don't use PMS twice, you may have your reasons for using the Connection application as PMS but most use BBS, Here is my Application line for BPQ32 APPLICATION 1,BBS,,N9PMO,PMOBBS,255 The other

On Sun, May 14, 2023 at 02:59 PM, Matthew Corcoran wrote: > > Hi Red, > > Propagation went south tonight... Here is my config at the time. I guess > my nodealias has been causing the trouble. Will try