You don't need the WW on the end, but it shouldn't cause the message
being sent to Winlink, so it sounds like a bug. I'll look into it,
but as Eric says removing the WW should stop it.
73,
John G8BPQ
On 08/01/2025 16:39, Eric H.
Christensen via groups.io wrote:
toggle quoted message
Show quoted text
The addresses shouldn't have .WW on the end. BPQ is
thinking these messages should be routed through Winlink and is
adding the RMS: part.? Remove .WW from your addresses and from
the h-route of the BBSs.
73,
Eric WG3K
FM18rp
Packet: WG3K@WG3K.#SMD.MD.USA.NOAM
E-Mail: wg3k@...
Sent from Proton Mail Android
-------- Original Message --------
On 1/8/25 10:21, jason via groups.io
wrote:
Happy new year to everyone!
?
New BPQ32 user here, latest version.? Running RMS,
Chat, and Mail.
?
A group of hams and myself are attempting to set up
forwarding between our individual nodes.?
?
Ham #1
?
Ham #2
?
When either one of us composes a message intended for
forwarding, it ends up at the intended BBS i.e. Ham #1's
message lands on Ham #2's board when addressed as above,
however the TO address ends up prepended with "RMS:"
instead of just landing on the board itself.? Is this
intended behavior?? If we didn't want it to do this "RMS:"
behavior, how would we stop it?? It makes it so that if
you aren't a sysop on the target BBS, the message doesn't
show up with a simple "ll".
?
Apologies if this has been addressed previously.? A
search didn't yield anything from what I could see.? Also
searched the docs.
?
Thanks ahead of time!
?
73
Jay NT0Y
