A few comments.
SIMPLE is primarily intended for use on systems without NETROM. Although I often use it from laziness I think it is better to explicitly set all the parameters, particularly when you are setting up a system with primary route over VHF and backup over AXIP.
Setting such a large quality difference will ensure that all available RF routes are considered before any AXIP. The main thing is to coordinate with sysops of local VHF nodes. Widely different settings on the same frequency can cause unexpected problems.
73, John
toggle quoted message
Show quoted text
On 13/07/2024 16:20, Chuck Gelm wrote:
On 7/13/24 10:08, Mark Taylor wrote:
I'm not real confident with your Quality and Minqual settings.
+1 with Mark.
Especially no NETROM on HF.
However, 'salt to taste'.
I think QUALITY should be larger than MINQUAL.
A QUALITY difference of +/- 10 or less might be sufficient to get the results you seek.
I recommend including SIMPLE before PORT definitions in your configuration file.
73, Chuck
