Nice. ?Its great to be able to make what you need.
Steve
toggle quoted message
Show quoted text
On Jan 13, 2025, at 7:56?PM, Andrei via groups.io <calciu1@...> wrote:
?
If you need to add the raised side guides, you can screw in a couple of steps.?
They are not precision anything, just keep the show from twisting when you lock it down or move it.
Well, my first "real" mill project is complete. Note that I had started before I had the drawings.
Not pretty, not to any kind of tolerance, but functional
Allen
Allen Underdown
allen@...
Sent from my mobile device.
Jan 7, 2025 9:25:31 AM Bill in OKC too via groups.io <wmrmeyers@...>:
Originally, yes, but corrected to the clamp plate later.
Bill in OKC?
William R. Meyers, MSgt, USAF(Ret.)
Aphorisms to live by:
Good judgement comes from experience. Experience comes from bad judgement.?
SEMPER GUMBY!
Improvise, Adapt, and Overcome.
Physics doesn't care about your schedule.
The only reason I know anything is because I've done it wrong enough times to START to know better.
Expect in one hand, expectorate in the other. See which one gets full first.
On Tuesday, January 7, 2025 at 06:40:57 AM CST, Brian Roberts via groups.io <bri7rob@...> wrote:
Drawing for the tailstock base....which IS what the OP asked for....unless I am mistaken?
?
http://vintagemachinery.org/pubs/51/29796.pdf
