I go to the N.A.M.E.S. show here in Michigan. They are always there and offer discounts. I agree their holders are expensive, but they are nice, but the inserts are reasonable.
Sent via the Samsung Galaxy S7, an AT&T 4G LTE smartphone
toggle quoted message
Show quoted text
-------- Original message --------
From: mike allen <animal@...>
Date: 2/19/19 6:18 PM (GMT-05:00)
Subject: Re: [atlas-craftsman IO] Atlas Craftsman 3950 back gear question #10d-260
??? ??? I have been using their HSS inserts for several years & like them alot
??? ??? animal
On 2/19/2019 2:46 PM, j7g3jj via Groups.Io wrote:
Just FYI, there is HSS insert tooling available in sizes suitable for your small lathe. ?
Kind of expensive IMO, but if you are looking for high speed steel rather than carbide, and are put off by freehand grinding your tool bits, this may be worth considering. ?
Contact Arthur R Warner Co. ?Latrobe, Pa ?723 539 9229. ?This contact info is rather dated, and if no longer valid, their website is listed ?as
.
Hope this is helpful. ?
