开云体育

Hi Jim I found the connector on: www.molex.com part number: 39-03-6064 Best 73 Sjoerd PA3DOL

You could also try the rear panel connector for FT857 or FT897, seeing as they are the same item, and more likely to be available Andy

I will look it up for Yaesu may still stock ?Get BlueMail for Android ?

Can someone give me the Molex/Waldon part number for the power plug for the FT847 (and cord mounted socket for it if you know)?? I see places that sell the cable but nowhere do I find the part number

Using a self-built circuit based on VK4SN. 73 Jorge CT1EXR Em seg., 5 de fev. de 2024 às 17:22, Hal Dale <wb4aeg@...> escreveu: -- *** Help us to save energy & paper - do you need

Has anyone had experience with using the digirig module with the FT847?? Hal/WB4AEG

Set the level for good speech on mic gain then leave it there, pad down input level to no more than 5mV rms KR Andrew ?Get BlueMail for Android ?

I set the audio level to just barely cause the ALC to move when in transmit mode.? I set the power control on the radio to give me the desired watts out.? I use this same method for all of the

So for SSB modulation, the volume level is what sets the output power to a large extent. So both the power output setting on the radio and the volume setting on the computer interact. How do you

Peter, correct.? After that, I use the actual power control on the FT-847 to set my output power.

Peter, That is exactly what I do when I use my FT847 with JS8. Steve NA4SA

No! If I understand you right. You must set your radio settings how you want. This is not the same power as on the software. There is a scale you adjust this to change the audio level. I think it’s

Call????? Envoyé depuis Yahoo?Mail pour iPad

Hey all. Just playing around with FT8 and reading up as much as I can. Many links and how to's mention that you just need the ALC to flicker. SO I have set the PWR meter set to ALC. So in regards to

Hmmm found the menu and the issue. I had the baud rate different. I made up a cable as per an online link. Once I changed the baud rate all went well....

you know you need a null modem type connection correct?? which cable type are you using?

Hey all. Tinkering around with an old (but newly aquired) 847 and doing what I like best and hooking up computers etc. I dont seem to be able to get any cat software to comminicate with the radio. is

I used to use a remote rig interface on my TS480sat with great results https://www.remoterig.com/wp/?page_id=1051 or https://www.remoterig.com/wp/ The FT847 will interface but you will need remote

You should check the serial number of your 847 against the version chart (somewhere on the 'Net - I forget where). The early versions could only be driven from CAT, not read from. Not being

Something as simple as a USB to RS232 adapter and then dev/ttyUSB0 normally My interface of choice is rather expensive but very reliable but you can get them from the internet here in the UK second