开云体育

Hi, Steven, I’ve had a few MD100’s and they have a common failing. The shield wire drops off and you lose microphone ground (not to be confused with signal ground on pin 5). The

I have a Yaesu MD-100A8X microphone connected to a Yaesu FT-847 radio and when I press the PTT the radio shows a carrier going out and the carrier is being seen by all parties but no audio. Through

Impeccable condition. Includes the following: - CW filter 500Hz - Signalink USB digital sound card for digital mode like FT8, SSTV, RTTY - RS232 to USB adapter for CAT rig control - Power cable with

Hi, In the past I have been repairing FT847's and now I have a surplus of replacement power buttons.These are genuine Alps Alpine from the USA and identical to those used by Yaesu (I've seen them

Hi Spence, restrict it to Yeasu only if possible, test equipment ok. Leighton. GW3FSP.

Go for it. As long as you aren't spamming all the time I think it might be OK. Micky K1XH Links: ------ [1] /g/YaesuFT847/message/766 [2]

Is it OK to post for sale items here? I've a surplus of an item and wondered if folks here wanted them cheaper than dealer price? Getting out of the repair business for a bit. de Spence M0STO

The USA frequency settings may extend the 40m band, if not just live with the full extension and you will also get 60M 73 Andrew ?Get BlueMail for Android ?

Hi All. I bought some years ago FT847. Rig is ok and good condition. Some years ago at OH we got extension to 7 MHZ. Here is allowed now up to 7200 kHz, and rsdio can transmit up to 7100 kHz. I have

For what it's worth... I did what is shown in the video years ago, paralleling the contacts and adding a 0.01 uf cap. It's pretty easy as the front panel tips down. Never had a problem. And I do

I would suggest you do not just turn psu on, it will more than likely have a voltage surge on switch on. Disconnect positive from psu, turn on psu and then connect positive. I have plenty of switches

There is a whole thread about low VHF power it may not be the output transistor KR Andrew Sent: 21 June 2023 13:50 To: [email protected] Subject: Re: [YaesuFT847] FT-847 power switch

HI Years ago I had the same problem too. Sooner or later it happens to everyone, it depends on how you use the radio to know if "BEFORE" OR "AFTER"... The first time I shorted the contacts with the

Hi all, Sorry it's in Portuguese but it's good solution too: https://www.youtube.com/watch?v=MoLWswLFwVA Maybe subtitles could help 73,

Mine was modified years ago when replacing the switch. Paralleled the contacts so both sets of contacts are used instead of just on side of the double pole switch. 73

As you have to strip down the whole front panel, I would leave it in the on position if that is possible, I would only strip down, if I could find a replica part. 73 Andrew Sent: 21 June

??????? ??? ??, 21 ????? 2023 ?-3:06 ??? ?Mitchel W2NEC?? <? mitchelrought@...??>:?

From what I have heard this is a common problem. I have heard that shorting the switch contacts to the unused pair on the pcb will get around the issue. But proceed at your own risk. I am sure that a

Hi Mitchel, personally I would not do that, might cause problems with the set and/or psu, I would suggest you fit a switch between the psu and the set in the positive feed lead. Leighton. GW3FSP.