开云体育

In the ALC connector

Sorry what shows 0.01? The 8 volt line? -- Greetings from Erik Rothuis (PA2ER), Terborg Netherlands.

shows 0.01 in reception and transmission

Have you tried master reset? Bob.

Hi, if you find you need parts for the FT-847 like the AF-CNTL board I have them all. Adam Farber W4AJF Cooper City, FL

Hi Andrew, he replied it is. Quote “ Yes, on all bands”. Sent while portable! please excuse typos.

First is this on all band LF, HF, VHF, UHF? 73 Andrew ?Get BlueMail for Android ?

First check the +5, and de +8 Volt lines, on J1004 of the AF-CNTL-UNIT. -- Greetings from Erik Rothuis (PA2ER), Terborg Netherlands.

Yes

?Anything connected to the ALC socket? If not, then check the socket to see if 0.1v is present on TX and that should rise to 0.6v on RX….. from memory. De Spence G5STO Sent while portable! please

Is it all modes as well? ________________________________ Sent: Monday, April 7, 2025 7:45:15 AM To: [email protected] <[email protected]> Subject: Re: [YaesuFT847] Excessively low reception

Yes, on all bands

Is that on all bands, HF, VHF, and UHF? -- Greetings from Erik Rothuis (PA2ER), Terborg Netherlands.

Hi, I have an FT-847 that appears to have no TX or RX on any band or mode, but it transmits at much less than a watt. When I put an antenna on it, I could hear myself very low on another radio in my

It probably depends on what software (and what version of it) you're using to drive the radio. If you're using rigctl, there's a separate radio model for the bi-directional and

One of my buddies is selling his 847, but it's one of the unidirectional models. Will I still be able to take advantage of doppler tracking and digital modes with it? Or do either of these require

I tried it and it works. Just connect it and use the tune button on the 847.

be interesting to know if anyone has actually tried an FC-40 (or the Mat-40 even) with an 847 successfully?

Thanks Spence. That was absolutely great of you to spend your time explaining that you have come up with similar logic I was thinking, so everything should be okay as you say “it has the same socket

Just to give you a little further reading. Also note the socket on some radios is inverted. Pinouts remain the same. FT847 and FC20 - reset pin to the bottom Inverted FT897 and FC30 - Reset pin to