开云体育

We can hammer out the details via direct message but it won’t be that much. You pay shipping both ways and for any replacement parts needed plus a small flat fee. Most likely it will just need a

I will sell you my FT-60 for $125.00 shipped.?Mike K6STU Copperas Cove Texas 76522. On Fri, Jun 19, 2020 at 5:48 PM, samer0214@...<samer0214@...> wrote: David, Not sure what the

Jonathan, I know for a fact that there was no water damage.? I had some alkalines in it last year, and they went bad with minor battery acid damage.? The radio was working fine (and still is now),

I just repaired a heavily corroded FT-60. If the main board is still operating and it’s just the button that’s not working I could probably fix it for you as well.

David, Not sure what the board number would be, but I checked eBay and didn't find anything.? Do you know what the board. model would be? Thanks - Samer K6SKH

Samer: You might take a look at what is available on E-bay. David KI6KAR Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10 Sent: Friday, June 19, 2020 2:45 PM To:

Hello, My FT-60R's monitor button stopped working, so I couldn't get into the settings menu. I took it to Yaesu for repairs, and they came back saying that I need a new main board due to water

The other repeaters, during the times when the ducting seems to be occurring, are close to 100 miles away.? The three repeaters' custodians have had conversations and our repeater does not usually

The scanner will likely be overloaded by the HT and won't hear the repeater.? AA3T Sent from our laptop

Thanks guys. Rick

Indeed! Very impressive Rick, Thank you! 73 -Brian n8wrl [email protected]> wrote:

Very nice job on the manual Rick! RandyN4QWK

If you look at https://rick.sparber.org/bg60.pdf, page 19, you will see the corrections I made. I don't hold out any hope that Yaesu will clean up their guide, which is why I wrote my

I have been following the problem Dora raised about a repeater that she says is in her area that she gas had trouble with. Many good answers have been given, but apparently Dora was still having

I'm not sure whether this was discussed: when the FT60 is transmitting, what frequency is being displayed? Andy

Not to mention it takes a short amount of time for the radio to notice the CTCSS tone and open the squelch. Anyway, I sure hope Dora comes back with whatever the solution to her problem turns out to

You do not "have" to have your PL decode on for your radio. You need it if you want to listen only to that repeater. I prefer to not use PL decode because then I can hear if there is any atmospheric

This information is in RepeaterBook. If it comes through the listserv, here is a shot of the repeater entry just S of my QTH.

So, if you are not monitoring “open tone,” you can key up and accidentally interfere with that other system - because you cannot hear if comms are occurring? -- Clint Bradford

Hi, Dora. Is it possible that the repeater output has a tone that needs to be decoded to open up the audio, rather than simply on the input?? In my area we use the encode/decode option, meaning that