On Jun 12, 2020, at 4:36 AM, Brian Smithson <brianesmithson@...> wrote:
?
Indeed! Very impressive Rick, Thank you!
73
-Brian n8wrl
On Fri, Jun 12, 2020 at 7:25 AM Randolph Urick via <raurick=verizon.net@groups.io> wrote:
Very nice job on the manual Rick!
Randy
N4QWK
-----Original Message-----
From: Rick Sparber <rgsparber.ya@...>
To: Yaesu-FT-60@groups.io
Sent: Thu, Jun 11, 2020 10:03 pm
Subject: Re: [Yaesu-FT-60] Question
If you look at page 19, you will see the corrections I made. I don't hold out any hope that Yaesu will clean up their guide, which is why I wrote my own.
Rick KG7MQL
-----Original Message----- From: Yaesu-FT-60@groups.io On Behalf Of Joe Alexa Sent: Thursday, June 11, 2020 11:19 AM To: Yaesu-FT-60@groups.io Subject: Re: [Yaesu-FT-60] Question
I have been following the problem Dora raised about a repeater that she says is in her area that she gas had trouble with. Many good answers have been given, but apparently Dora was still having trouble.
I remember when I first received my FT-60 I had the same issue. I searched the web for answers and found one that cleared it up. It was the numbered sequence of instructions on page 22. If Dora’s manual is like the one I recently downloaded, which is the same as the one I have, (2 years old) this could be her problem,? if she tried to follow the sequence as listed.? Step ‘3’ must be skipped, then proceed to step 4 then 5 and 6.
Apparently Yaesu hasn’t cleared up these instructions. I Renumbered? the sequence 2 as 2a, and changed ‘3’ to 2b, 2c and 2d; then 4 became 3 and so on.? The steps 2a to 2d could be used to set up the other codes should you want to use them later.
