Roll your drivers back to Prolific 3.2.0.0., if you have a Prolific chipped cable. Should work fine, then.?
Jardy Dawson WA7JRD
Message sent through sub space hailing frequencies?using the Universal Translator.?
toggle quoted message
Show quoted text
On Dec 24, 2018, at 04:31, Mary <
m-moon@...> wrote:
Hi
When. I upgraded to win10, I could not use CHIRP anymore.?
I had the error you describe and others not recognizing port.
I tried different cords. Nope.
Some folks said I needed to go back to older drivers and others said I had to get newest drivers.
Thinking I will next try a new computer that started with win10 and was not an upgraded one.?
If I get it to work I will post the solution.
Kk4GOW?
On Dec 23, 2018, at 1:20 PM, k6whp <
k6whp@...> wrote:
I checked the previous messages (perfunctorily) and did not see a direct answer to this question so my apologies for any repetition. In attempting to modify a code plug (add frequencies) to my FT60R, I thought I'd give? Chirp a whirl.
It read the data from the radio accurately and without incident. However, when I attempted to write the data back out to the radio, the dialog comes up with the vendor and model edit boxes disabled. Any suggestions or ideas?
Thanks in advance!
--
William, K6WHP
"Cheer up, things could get worse..so I cheered up and, sure enough, things got worse!"
