Hi Rick,
You indicated that the instructions as documented in the manual were
incomplete or inaccurate. I just posted to disagree. If you want to
start the process of assigning a given memory slot to a memory bank, you
may start from "NO BANK" if you want to, but you don't *have* to if the
memory slot you're interested in happens to be assigned to the currently
active bank.
-Don, KE6DM
toggle quoted message
Show quoted text
On 6/22/2014 4:03 PM, 'Rick - yahoo' rgsparber.ya@... [FT-60] wrote:
Don,
The reason I wanted to start at NO BANK is because if I am in any other
bank, I am limited to the memory locations stored in that bank. What am
I missing here?
73,
Rick
KG7MQL
*From:*FT-60@... [mailto:FT-60@...]
*Sent:* Sunday, June 22, 2014 9:04 AM
*To:* FT-60@...
*Subject:* Re: [FT-60] The Assigning Memory Entry function
The procedure as written in the manual works for me. As long as you're
in memory mode, the memory slot currently selected is the one that will
be assigned to (another?) bank. Your step 1 shouldn't be there, and the
others repeat (with embellishment ;-) ) what's documented.
-Don, KE6DM
------
Sent from my HP Touchpad running Android Jellybean!
On June 22, 2014 7:42:11 AM PDT, "'Rick - yahoo' rgsparber.ya@...
<mailto:rgsparber.ya@...> [FT-60]" <FT-60@...
<mailto:FT-60@...>> wrote:
I have found a few steps missing from what is in the book. This works
for me. However, since it was trial and error, it is possible that some
of it is unnecessary:
Assigning Memory Entry (page 33)
1.Start at NO BANK
2.Recall the desired memory channel
3.Press and hold BAND until SEL starts flashing and BAND # shows where #
is the band number
4.If necessary, rotate the dial to select the desired Memory Bank within
3 seconds
5.Press and hold F/W till you hear a beep and then press V/M momentarily
I would appreciate it if others would test this out.
73,
Rick
KG7MQL
Don McKee, KE6DM