开云体育

Somewhere in the service manual I thought I saw a comment about using vintage impedance voltmeters for everything accept some lightly loaded RF stages, where a high Z vacuum tube volt meter is more

Hello group, I have an FT-101EE and am wanting to measure the various voltages off the main transformer. What type of voltmeter is needed as far as ohms/volt is concerned? I own several. VTVMs,

Try exercising the switch, end to end, 20 times. If that helps give it 20 more. I find that any radio that has not been used regularly can benefit by exercising the switches. It wipes any oxide off

With the switch on “IC” rotating “Drive” increases the reading as expected, and rotating “preselect” moves the needle as expected. When I switch to “PO” the needle goes to 0 and stays

I agree with the below Until you can solve the meter issue you could try: At plate dip, power out should be max – measured on external power/swr meter - provided the final tubes are aligned

Would changing the SSB filter to a 2.7KHz filter improve RX audio quality on SSB / AM? Sadly the 101ZD has no switchable filter for AM / SSB and I've got a spare 2.7KHz Yaesu filter 'flying'

Your description of the procedure you carried out is not too clear.? when you worked through the tuning/loading process did? the equipment respond as it should?? ie load giving an Increase in Ic

I had an FT-101B that had been in storage for over 20 years and fired it up. At first it worked and then didn’t. I found that there were two small diodes in the power supply that had died,

Hi All, Having trouble with my FT-101Z. ?It has been on storage for about two years and was working before this. I have forgotten a lot about using it. ?During the Final Tuning procedure, the PO

THIS IS STILL AVAILABLE AND STILL A GOOD DEAL! ?I have an FT-101ZD for sale. ?It's in excellent working condition and about 8/10 cosmetically. ?It will also come with an outboard second VFO. Photos

I am trying to un-modify an FT-101 EE to restore CW operation in a radio that has an AM filter and the mode switch modification installed. Everything seems to be OK from the pictures and directions in

I HAVE THE FL101/FL101 PAIR BUT WHATS MISSING IS THE UMBELICAL CORD LINK THE PAIR , THE FL101 HAS BEEN REPAIRED AFTER A LIGHTNING STRIKE AND NEW VALVES , AND SOME WIRING REPLACEMENT , WOULD BE GREAT

As and when someone fixes this radio I would be interested to know what the fix was. Al GM4ENF

This is great info, thanks!? I just tried to adjust it with the trimmer pot, and I could get it sorta close as long as the screw driver was on the pot, but as soon as I took it away, the marker tone

Never mind, I found it....

Looking on QTH but don't see it.

Thanks for the input, I can't find the elusive FH2 by tracing, using magnifying glasses, bright lights, mirrors, etc so I'm done with it. It's now listed for sale on QTH.com.

Your three local oscillator crystals, USB LSB CW.... could be off frequency too.

OK. Does your radio have the WWV receive crystal installed? If yes, tune the receiver to it and zero beat the carrier while listening with headphones. Then off tune a bit so you hear a 400hz to 800hz

Thanks Bruce. Something is off somewhere, I'm just not sure where. I know that if I pull up the 14.300MHz Maritime Mobile net, I can center the VFO dial on 14.300 and hear the net fine, so I feel