开云体育

Hi Mike, The FT-101EE didn't come with a speech processor. Possibly the wire was left for adding the processor later on. 73 Roger VE7LB

Inspecting my 101EE, I discovered a wire that apparently at some point got snipped. I cannot see anything that looks like where it was originally supposed to go. It's located under the PB-1092

Thanks to all who replied. I think I'll take the readings with both high & low impedance meters and see if there's any noticeable difference.Again...thanks!MikeKD7VRGTucson, AZ

Those voltages are nominal. Plus or minus 5% is fine. Use any voltmeter. Peter G0LQU Roger VE7LB wrote:

For measuring your transformer voltages all of your meters (VTVMs, modern DVMs, Simpson 260 etc.) will work fine. The accuracy will be determined by the calibration accuracy of each meter. Circuit

If you want to use a high impedence digital voltmeter, parrallel the VOM input probes with a 10k ohm resistor for up to 10 v. 50k for +10 to 50v, 250k for higher voltages. This will "load" the

To measure the output of a transformer a good dvm will do the job, just remember the off load voltages will be higher than when its connected and under load. I've just replaced the transformer on an

Somewhere in the service manual I thought I saw a comment about using vintage impedance voltmeters for everything accept some lightly loaded RF stages, where a high Z vacuum tube volt meter is more

Hello group, I have an FT-101EE and am wanting to measure the various voltages off the main transformer. What type of voltmeter is needed as far as ohms/volt is concerned? I own several. VTVMs,

Try exercising the switch, end to end, 20 times. If that helps give it 20 more. I find that any radio that has not been used regularly can benefit by exercising the switches. It wipes any oxide off

With the switch on “IC” rotating “Drive” increases the reading as expected, and rotating “preselect” moves the needle as expected. When I switch to “PO” the needle goes to 0 and stays

I agree with the below Until you can solve the meter issue you could try: At plate dip, power out should be max – measured on external power/swr meter - provided the final tubes are aligned

Would changing the SSB filter to a 2.7KHz filter improve RX audio quality on SSB / AM? Sadly the 101ZD has no switchable filter for AM / SSB and I've got a spare 2.7KHz Yaesu filter 'flying'

Your description of the procedure you carried out is not too clear.? when you worked through the tuning/loading process did? the equipment respond as it should?? ie load giving an Increase in Ic

I had an FT-101B that had been in storage for over 20 years and fired it up. At first it worked and then didn’t. I found that there were two small diodes in the power supply that had died,

Hi All, Having trouble with my FT-101Z. ?It has been on storage for about two years and was working before this. I have forgotten a lot about using it. ?During the Final Tuning procedure, the PO

THIS IS STILL AVAILABLE AND STILL A GOOD DEAL! ?I have an FT-101ZD for sale. ?It's in excellent working condition and about 8/10 cosmetically. ?It will also come with an outboard second VFO. Photos

I am trying to un-modify an FT-101 EE to restore CW operation in a radio that has an AM filter and the mode switch modification installed. Everything seems to be OK from the pictures and directions in

I HAVE THE FL101/FL101 PAIR BUT WHATS MISSING IS THE UMBELICAL CORD LINK THE PAIR , THE FL101 HAS BEEN REPAIRED AFTER A LIGHTNING STRIKE AND NEW VALVES , AND SOME WIRING REPLACEMENT , WOULD BE GREAT

As and when someone fixes this radio I would be interested to know what the fix was. Al GM4ENF