开云体育

Thanks Donald.

I found this one with a simple search: /g/FTDX101D Not sure how you missed it. I used this search term in the groups.io search: FTDX101D The only other related group was about

Brian . . . I don't know that there are specific groups for those radios, but the FoxTango group might be a good place to post your questions. Also, the amateur-repairs group is good for all sorts of

Hi. I've searched Groups.io for a user group for the FTDX101mp or? (FTDX101D) - but can't find one. Can someone please point me in the right direction on Groups.io or elsewhere? Thanks 73, Brian

Check the transistors emitter. since there is a capacitor. you shouldn't see much of a signal if any.? The bypass could be bad, and that could cause low gain and the output to be incorrect.73.RB

Idon't think I have worked on TTL for 40 years. As I remember a low is less than maybe 1/2?Volt and a High is at least 3 1/2 volts. The circuit input should never go negative. Usually a shotkey?

Hi all, As a weekend project I decided to attempt to repair a non-working YC-500 frequency counter "just for fun." The problem I have identified so far is that it does not generate its internal 1 MHz

first success.... With the RIG File FT-847 it runns ...(a bit) But QRG changing, and PTT only - sound was no problem No Mode, Bandwith etc are working If I see the cat commands possibility of

Hi, connection was no problem. But can't configure in FlRig/FLDigi - has no Rif File (XML) Tried FT-817/817nd/FT2000 .. no success Which Baudrate (I prefere 4800 not/less sensible for

Selling is allowed in this group for ham radio equipment only, and at least one of the items for sale must be related to the purpose of the group. We require that anything being sold here have a price

Has anyone successfully got the rigpi/ftdx5000mp to operate over the internet ?? Also need to control 2 g1000 rotors.? Any info will be help full .? ?K0BBB duane

Marc . . . Try also posting this in the Fox Tango group and the amateur-repairs group. One of these should get you your answer if this one does not. Our group here is still small and new. Donald

I wonder if any of you Yaesu exerts know of a work around for the usually very expensive AM filter in the FT107m. Drake had a resistor across the filter pins as a cheap

I have a recently acquired FT-107m that works amazingly well, except the power out on 80m is a bit low. All other bands are 100w or better (10m slightly less). All tested into a 50 ohm dummy load. My

Yaesu HF Transceiver, Power Supply, DTMF Hand Microphone, and more For Sale: . Yaesu FT-840 HF Transceiver: The compact Yaesu FT-840 has two direct digital synthesizers and rotary encoder

I finally figured it out after studying the schematic for the power supply and the rig. Looks like pins 1&3 are connected when using the internal ac supply.

Hi vy nice in RIGS FT-857 / 897 the CW Tuning LED (goes to blue if QRG matches) I enjoi this really. This I am vy missing in FT-818 Now sometimes use the Wolfwave or a DIY Audio Filter - but then

Mark . . . Perhaps someone in the other groups I linked to can help. Donald KX8K ---------------------------------------------------- Some ham radio groups you may be interested

I have the manual. It just doesn't discuss how this plug is wired. I suspect it's pretty simple, because there is only a plus and minus contacts. Thanks for the other suggestions.

Marc . . . For things like this, I like to increase my chances of getting the information I need by posting in other relevant groups, too. These would seem to be other good places to join and