开云体育

And I bought four :( So I'd like to know as well... Regards, Bob Gamble <vinny.derobertis@...> wrote:

When Karst recommended the GSMA, I immediately bought 2 of them and I never saw the updated recommendation to use the GSMB. I assume the GSMA is "good enough" or is it worth spending the $ for the

You are right :)

Have you change the preferences in JMRI to use the network rather than USB? Sent: 06 December 2024 08:35 To: [email protected] Subject: YD7001 and decoder pro I recently upgraded from

I recently upgraded from the dr5000. ?All seems good and I decided to switch over to using a LAN connection instead of USB between my PC and the YD7001. The unit now shows the IP address on the front

Hi I have been discussing the possibility of the DR60710 power supplies destroying the equipment it is providing power to (YD7001 command station, DR5033 etc.) and what we should consider for a

But that is for the incorrect "A" version ;)

Yes. xx means 15 or 18 Volts. AFAIK that are the only suitable versions in the series.

Attached is the Meanwell Data Dennis Cherry

So what Axx units do you recommend? The XX means the DC voltage output? 'N", HO, O, etc? Dennis Cherry

Correction, it is the GSM60 *B* xx-P1J series

Hi Jay, Oh YES it can ! Look.... But first: It *CAN* be Short on the DC side, *must most likely* it's the Voltage-Selector slider that malfunctions or any of the internal capacitors get bust.

I appreciate this is an older post, but assume the right product is the GS M 60 *B* 18-P1J version, as double insulated (the box in box symbol). The "A" version is not. Brgds, Rene

Hi There is a post on the FaceBook group *Z21, YaMoRc, Digikeijs & automatic control users group ( https://www.facebook.com/groups/1346790392010051/ )* that suggests that if there is a short on the

Correct

Karst Does it therefore change (P-N-P) (P-N-P) to (N-P-N) (N-P-N) as two independent outputs? Sent: 29 November 2024 14:08 To: [email protected] Subject: Re: Using YD6942 There

There is no manual, instructions are on the bottom-side of the PCB ;) YD6942-Bottom.png ( http://yamorc.de/wordpress/wp-content/uploads/2022/11/YD6982-Bottom.png ) Just 1:1 connection to the

Does anyone have a diagram showing how to wire up and use the YD6942? It might be a solution to a problem and I would like to know how it used :) Or has anyone seen manual? Thanks

no problem

I bought my kits from https://www.railwayscenics.com/ ( https://www.railwayscenics.com/ ) These seam reasonably priced to me.? I am not an electronics engineer but I can solder and follow