开云体育

There is a folder on this site where you can find almost all the DK firmware. Just log onto this site and look for it :) Many Thanks Iain Morrison https://wimorrison.com/

Thanks will do! It seems that my dr5013 V1.1.0 firmware is corrupted though , hence the USB connection issue. Do you know of a site I can download a new from , as Digikeijs is no more? (I have

If all you need is an auto reverse with no feedback then you can get something like the Block Signalling Auto reverser for a lot less than a LK200. There are some available that are cheaper. Iain

You are right again about the LK 200 For my loop though I only need a module with short sensing capabilities so maybe the DR5013 is an overkill

The LK200 is an old Lenz module and that doesn’t provide any feedback at all, whereas the DR5013 is a newer device and provides feedback over Loconet therefore you are not comparing apple with

Initially I thought so too but who do I reconcile the finding that whe I use a different reverse loop module (Lenz LK 200) I have no issues at all? . I know that buying another LK 200(not

The message you suggest is not a short circuit message, it is a logic message from RocRail that suggests to me that you have the block lengths, speed profile, or even block connections wrong – but

Thanks so much Iain for your input I modified my setting according to your suggestions with no success. Obviously you are correct it is indeed the CS that is detecting the short. My question is

I have a DR5013 used in the way you suggest (but with a Z21 and iTrain) and suffer none of the issues you describe. For the record and correctness it is not RocRail that is detecting the short

I'm using the DR5013 short detection capabilities to manage a "simple" reverse loop .? Following? the manual's instructions? I didn't modify any of the factory settings (no value assigned to S0-S3

I just upgraded to the UR93 as the UR92 had difficulties acquiring locos with the YD7001. Actually the main problem wasn't acquiring locos as much as it was consisting them. Now that I have upgraded

For info 2 x 220 micro farads worked, no buzz. I still don’t understand why a standard LED works from the output of the DR 4018 but a flashing one doesn’t. Pity because it means lots of extra

Thanks Iain. I am using a separate power supply which I thought was stabilised but probably isn’t. I will experiment with a small capacitor and see if that works. Robin

Robin How are you powering the DR4018? If you are using DCC then you will have rectified DCC as the output and what you are hearing is the ripple from that rectified voltage. A small capacitor

I posted a question earlier regarding the DR4018 not being able to operate a tiny LED with built in flasher, it operates a normal LED with no problems. The recommendation was to use a small relay

Except for 1 thing. Karst, the developer, emphatically states below that you should not be using common power supplies for HBridge components. I know people have stated that it works and it obviously

Update! While working with Thomas Ose of?OMS(re)models.com, who is very familiar with this system and a friend of mine. We have it resolved. I had to reverse wiring on the 4 5033s and configure the

Jim, Hover your mouse over the IB box. It says "The ID with which the YD7001 reports itself in Slot 0". Sounds like I would never need to know it unless I was doing logging analysis.

Adam, Thanks for the idea/solution.? I'm familiar Arduinos.? I use them to drive my servo controlled switch machines.? To finish it, Ryan fro Iron Planet Hobbies offered to reprogram the DR5033s

Thanks Oldngrey, I found that one of the DR5033 was not set properly and matched it to the other 3 units. Looking at the Expert tab, I am wondering what this setting should be? IB or YD? And what