开云体育

USB if the cable length is <= 2 meters

Attached is an image of the invention of antiparallel diodes to lower the voltage. It would be 15v to 11.5v In the Scale Z forum in Spain it indicates that this is a good voltage for digital. Each

Thank you very much again for your help. Just one more question if you allow me on this topic, what do you advise me to control the model, through USB or LAN cable? Mario

Thank you so much for your help. What a joy.

The YD6016 does not have a thing to do with this. It will detect current, not voltage. However... using the YD6016xx-CS will drop the voltage for about 1.1V.? The current sensor is built with two

Don't need that, just plug the DR4088RB into the YD7001 and the MultiMAUS into the DR4088RB. We are a bit more advanced than Roco with the Z21. We doe R-BUS and X-BUS on the same cable ;)

Direct Cable connection between YD7001 and PC (

No Problem, just use a mono-stable spst relay. You might set the Pulse-Length in the YD8008 accordingly ( default = 30ms ) Greets, Karst

The forum email has been changed to [email protected] Welcome page will be corrected later today. -- Dennis Cherry Owner/Moderator

Hi, Is it feasible to drive 12v relays from a YD8008 that has YD6940s? I need the relay to only operate for about 300mS or a little longer in order to be the momentary trigger to an input of a timer

Ok, De acuerdo. Me parece perfecto. Okay, Okay. ?That seems perfect to me.

You need to give the PC and the YD7001 fixed IP addresses on the same network, e.g. 193.168.0.1 for the YD7001 and 192.168.0.2 for the PC. They will both need the same subnet mask 255.255.255.0. Then

Would an adapter of this type be worth it?

Good afternoon. The idea is to connect directly from the PC's network card to the YD7001-E without using any router. I have seen somewhere that no crossover cable is necessary but I don't know what I

I hope this helps. From what I can see the PC and the YD7001 are on different networks. The PC is 192.168.1.80 the number one being key here. Also the PC address is manually being assigned by the PC

Sounds good, thank you Dennis.

Good morning. This is where I have to modify the IP of my PC and put what the Yamorc YD7001-E indicates? Sure, I have to see what my YD7001-E indicates Thank you so much. Greetings, Mario

Deems logical.

Dennis: The new name is good. Thanks, Don Charabin [email protected]> wrote:

I will be changing the Groups.io email from [email protected] to [email protected]. If you have any other suggestion for the new email name please let me know in the next 2 days. This was