开云体育

Hi you just hit THE DR5000 UDP-bug :D ( and at the same time one of the reasons of existence fort the YD7001 ;) ) The Bug implies, that things like Turnout-Position, Feedback State, Loco Speed are

You may have too many devices connected. The actual Roco z/Z21 can only handle 8 connections reliably and IIRC the DR5000 is fewer. Iain Morrison https://wimorrison.com Sent: 12 March

Just putting this one out there. I am currently updating a club layout from the Hornby railmaster system. I have found the dr5000 very successful in the past whilst working with the z21 program. I'm

I find it interesting that you have to start JMRI first as I have always found the opposite. Glad you got it working. -- Heath @ Human[c]ity http://www.humancity.org ( http://www.humancity.org/

To finalize the story: it now all works. I got JMRI to populate the sensor table as I switched each turnout and as I drove a loco along each track. Not too surprisingly I got a few wires crossed over

Thanks Karst, I'll give this a go! Paul

and then is the way to go with the YD8116. Greets, Karst

Hello, I hope somebody can help me setting up a Yamorc YD 8116.??Please excuse the long post! I have several Fleischmann 22212 electromagnetic decouplers on my layout.??I want to be able to

Well I have some progress. I doubt anybody will find it useful, but here it is anyway: * I use Tortoise switch machines. * Some time ago Tortoise changed the edge connector so if you were using a

yes mate all turned off wrote:

Wow! ?Thats pretty good service to replace all of them for you, I didn’t realise it was a known issue. ?I have about 20 of them and some or all of them lose their address at regular intervals.

I accept you don’t use Railcom but by default it is switched on with a DR5000 and is therefore present in the DCC signal. Did you switch it off? Iain

i never use rail com Ian but still have the problem i was in touch with DCC Concepts and Digikijes at the time but none could answer the question of the problem

DCC Concepts stuff is very sensitive to Railcom when it present though snubbers seems to reduce the issues, the only real ‘cure’ is to switch off Railcom (and that is what they will tell you to

i have had that problem for years changed all my digital ips for new ones but once i connect them to the dr5000/yd9401 they start going erratic and their addresses change still got the problem im

Earlier (over 2 years ago) Digital IPs had this issue. DCC Concepts sent me a box of newer ones to replace them.

Ok, Then your pre-req's are Ok, Swapped 5033's already ?

Each DR5033 and the YD7001 have their own 15v power supply that came with the module.

Which Power Supply do you use un the DR5033's and The YD7001 ? And do they all have their own PSU ? Greets, Karst

Heath, Useful because one of my concerns was that it simply wasn't a valid design. Here's why: * In some discussions the track output wires do matter in boosters. Others mention it is an H bridge and