开云体育

The Train Tech SC1 will only do 2 aspect signals, for 3-4 or route control I think you need the sc2, 3 or 4, this is why I went with the CR signals one, it will do more on 1 Board. I’m running the

Paul mention about SC1 . from CR Signals . I got the Train Tech SC1. Not sure if this will work? on a DR5000 system though I can get two aspects working.? When it comes to Three aspects or with

Andrew, I used CR Signals SC1 board for the feathered signals and that runs straight off the feed from my DR5000, the others go into a 4018 run from my 5000. Andy

Hi Andrew Mine are from CR Signals. from Paul . But I make my own I just get the molds from him only . yes I have feathers on the signals as well. Been making Y one's to. This is all new to me what

Andrew, who are the signals made by? All mine are CR Signals, I’ve 2 with feathers that run off the decoder board from them, the others go through the 4018s, I only did it this way as the feathered

With locobuffer-N that i have .can you use this with the DR4018 . Trying to find a accessory decoder? to operate? three aspect signals Or do still have to get the DR5000 to operate the system Andrew

I would also be interested in knowing why not.? I haven't run across any issues with having more than one connected. In fact,? I attend a regular op session that has 16 Roco WLANmaus all connected

Why not?? Details please!

I’m on the same one so not that, the DR5000 has it’s own wifi and both tablets were set to only connect to that so no problem on that front as both were operating at the same time using the dual

I am using the ‘new’ version and I would suggest that if the issue happened at an exhibition then it was probably down to network contention (phones also cause issues as they are broadcasting all

Hi Iain, Which z21 app are you using the new or old version? I can definitely confirm the point switching not being noticed on one tablet when switched by another as I was running my layout at Calne

Rick, If there is a possibility of a turnout being thrown manually then you will need to add a senor trigger to the the turnout.? ?Like some kind of micro switch. Use the micro switch to trigger a

Iain, Thanks for the additional reply. I do not yet own a system so have not had an opportunity to check this out first hand.

Thank you Iain and Andrew for your helpful responses! My original concern was someone throwing a set of points by hand, likely a rare event but could happen with young children. You both brought up a

Have you disconnected the DR5033 output and checked if the Booster now operates correctly? I remember a post somewhere that a person had a problem with a certain Power district module and it was in

What you do need to careful of is having multiple tablets doing the points, as from experience I’ve found that if someone switches points on their tablet it will not show on yours that it’s been

Rick What do mean by manually? If you mean someone physically switching the turnout by pushing the blades into another position then that action will not be replayed in the Z21 app. If you mean

I am pleased to see that one can set up a digital control panel on the cell phone with the Z21, DR 4018, and atlas turnouts.? Do the Z21 and DR4018 indicate the correct turnout position if the

Hi James, I think I have found the problem. It looks like a dead booster (5033) as there is now zero track voltage from the output. The green power light on the booster illuminates/flashes when the