开云体育

Any word on a setup manual for YD7010 or quick start guide?? They had been shared earlier but were incomplete due to your writer being hospitalized.

I have looked in the manual since finding this, and I have not found anything regarding short protection. -- Heath @ Human[c]ity http://www.humancity.org ( http://www.humancity.org/

After installing a YD 9401 into my DR5000? and dowloading the config software, I then installed it,? the activation message did not appear. The config software was re installed again still no joy,

Thanks Iain. You've come to the rescue yet again! I'll add it to the files section in the next few days. Matt

I have 4 x DR4018 running 32 x 2 aspect signals with CV47=2. The signals show steady lamps and fade gracefully between the aspects when changed. You may have set the brightness too low and are

Has anyone been able to get the DR4018 to issue a steady Signal light when CV47 is set to 2 ?

It is nothing to do with having an earth in the outlet, although you should use such if using earthed equipment. In Europe (where outlets are earthed) anything which is exposed and powered like track

DR4024-Manual.pdf <https://archive.traintastic.org/digikeijs/DR4024-Manual.pdf> Feel free to upload it ? Iain Morrison 07767 456746 <https://wimorrison.com/kaninchenbau>

Hi Please does anyone have a copy of the DR4024 servo decoder installation software and instruction manual they could upload? The file in the files section is empty. Thanks (with fingers

Hello, (I have not read the manual, my apologies in advance. Today during an operations session, there were many shorts, a good amount caused by operator error, but other from normal things. All the

Karst, our club is in Toronto Canada and we will be replacing all of our Digikeijs booster and command station power supplies. ? I assume that thee 3 prong version, GSM60A, is the better choice for

Or try to look at other messages in this group.... /g/YaMoRC-Digikeijs/topic/109954783#msg4676

You could try JMRI's instructions for the DR5000 JMRI Hardware Support - Digikeijs (Digirails) ( https://www.jmri.org/help/en/html/hardware/digirails/index.shtml )

Ok, great setup ??

No, the YD70xx need a minimum of 14DC. that renders 12.8V to track out.

I think my last question is answered if I can use the GSM60A12 - that will give me 12 volt output. Are there instructions on connecting JMRI to the YD001?

Good evening. What if it is a USB connection? Thanks

Buenas noches. ?Y si se trata de una conexión USB? Gracias

OK thanks Karst. My layout is also 00/H0 and the longest locomotive is about 28cm so with S1 and S2 planned at approx. 60cm each and the Track Out still having a length of over 4m I'm well within the

I have it tested here with only 10cm length in H0. Also works, but that pre-requires your sections adjacent to S1 and S2 to also be suplied with a currecnt sensor.