开云体育

SOLVED! I had the connections matching Karst’s second as in JMRI 5.8 unlenbrock and TCP is not an option. nevermind, this wasn’t my problem… when using Loconet over the network one needs to

Karst, I've been happily using the LAN connection for a while now using "LocoNet over TCP" with the command station type "DCS100 (Chief)". It works just fine. I think I got that config from the JMRI

and a more recent version:

Here is what works for me: greets, Karst Note, this is an older JMRI (V3)

I will leave it three prong and trust the design. It is better than the one that destroys equipment! Regards, Bob Gamble [email protected]> wrote:

I wouldn't do that unless the power supply is marked as double insulated class II unit, then it will usually have a 2 pin connector. Power supplies often have filters that are grounded, if you cut the

Yes, I have tried using these settings as attached.? (I don't have the Loconet over TCP server running in JMRI )

Reading all this I can only say I'm glad I ditched nearly all the digikeijs smpsu. I got fed up with high touch voltages to earth on my rails. Go on, try it, put a high impedance meter between your

When you say the A is 3 prongs and the B is 2 prongs, are you referring to the plug on the end of the wire? If 3 prongs refers to the UK style plug then the A version needs to be ordered for the UK

Thanks all! Happy Holidays

Yep, just cut off the plug to disconnect the PE wire. That's the difference. Greets, Karst

Here is the GSM60B Data sheet. Dennis Cherry

Looking at the data sheets for the two, the only difference I can see is that the A has a three prong power cord input whereas the B uses a two prong input. I'll stay with the A. Regards, Bob

And I bought four :( So I'd like to know as well... Regards, Bob Gamble <vinny.derobertis@...> wrote:

When Karst recommended the GSMA, I immediately bought 2 of them and I never saw the updated recommendation to use the GSMB. I assume the GSMA is "good enough" or is it worth spending the $ for the

You are right :)

Have you change the preferences in JMRI to use the network rather than USB? Sent: 06 December 2024 08:35 To: [email protected] Subject: YD7001 and decoder pro I recently upgraded from

I recently upgraded from the dr5000. ?All seems good and I decided to switch over to using a LAN connection instead of USB between my PC and the YD7001. The unit now shows the IP address on the front

Hi I have been discussing the possibility of the DR60710 power supplies destroying the equipment it is providing power to (YD7001 command station, DR5033 etc.) and what we should consider for a

But that is for the incorrect "A" version ;)