开云体育

UPS just told me that they delivered to a guy called MATTHEWS :)

I have three DR4088LN-OPTO. The red flashing LED is normal to indicate that any of the channels is "active". Depending whether your sensor is setup to be active high or active low will dictate whether

one hundred percent normal ;) The LED flashes whenever data is being produced by the module ( or any upstream module ). It "counts" active inputs. It seems to me your Sensor works inverted => Active

I would think that the current of the short is being shared between the two boosters. Since you measured this to be under 6 amps, neither booster trips. You could block off the section of track

I have an identical setup on my layout except I have DCC concepts digital ip instead of tortoises. ?I’ll check it out when I get chance. ?Although I’m not sure what a Zorra is…? Adam

I've got a DR4088LN-Opto successfully connected to an infrared sensor (or so I think!).? The sensor correctly reports to iTrain when the IR beam is blocked. There is a small red light on the

Hi Brian I should have added that on the diagram the black lines diagonal to the track left of the turnout represent the gaps that are cut in the track to isolate the power districts.? So the frog is

Jay, Not an answer but a question, why are you feeding the frog (green wire) from both booster 1 and booster 7? I would have though the frog should have only have power from one booster, probably

Hi I quickly created a diagram of the described situation this morning.? The top picture represents a train coming on the lower track toward the switch that is set against it, and the lower picture

Hello Dennis I have a zoom account for the business so we can use this if you like on the odd days. May Thnaks [cid:image001.png@...] James Hudson Director 01823 429309

Hi I have been trying to figure out good wording for the question for a few days.? It is a little complicated to describe the track configuration and what is going on, but I will try here an see what

Yes James, Zoom is very good App and would be my go to also. Since this is a no cost forum to the members, it would be an out of pocket expense for me. Cost for any Zoom type room App for more than 2

Hello Dennis Why don’t you just use Zoom? [cid:image001.png@...] James Hudson Director 01823 429309 https://www.dcctrainautomation.co.uk/ Unit 15, Bowdens Farm, Hambridge, Somerset,

Si quieres enviar a Espa?a, orden de DCCtrainautomation en el Reino Unido (https://www.dcctrainautomation.co.uk/), o Modellbahnshoppe Lippe en DE (https://www.modellbahnshop-lippe.com).? Será más

Sincere condolences Karst.? Been through that and it's tough.

When I ordered mine this morning there were 48, so going fast!

I ordered mine. Only 23 left in stock! Alex wrote: -- Alexander Wood Hartford-New Haven, CT Modeling the modern era freelanced G&W Connecticut Northern in HO Digikeijs DR5000 - JMRI - ProtoThrottle -

That worked thanks

I would think that it would be better to order from a UK or European store if you want delivery to Spain. It Should cost less overall. Bob

There is also RED Flashing ==> GP_OFF on LocoNet received. RED then Flashes in counter-phase with green. The green is very yellow-ish. That's why for YaMoRC I choose real green for green ;) ( as I did