开云体育

Yes You cab set it up as a IC-7000 and it works no problem. You will need the CE19 interface which comes with the necessary leads. Sent: 23 July 2022 12:14 To: [email protected] Subject: Re:

Try loading an earlier firm wear version.? Make sure you're following the instructions for the version of the firm wear you're installing.? I don't recall all the issues I had, but I think I

Set WSJT-X communications to be for an Icom IC-7100. XIegu uses the Icom CI-V communications protocol.? But only partially!? You can control frequency, mode, TX/RX and maybe a few other things, but

Thanks guys, I’ll give this a try this weekend and report back

Hi James Yes I have heard that some users have tried 10 or more times with apparent successful upload each time before success. I have tried this with no luck so far.

Hi Kevin Thanks for the tip had not heard about that one….but using Teraterm. 73 Steve

Are you using minicom or something on Linux?? Not going back to charge/standby is typical unless you use the Teraterm xmodem application to load firmware. Good luck! Kevin W2NC

Could this be another "failed firmware flash" case (initially by the previous owner)? Other posters here have advised that the flashing process can be very sensitive to both the Serial-TTL interface

Hi JP Thanks for the reply. Was not working when I got it. I suspect that although I was able to update the firmware, the battery was too low to turn on.However having now recharged it directly, I

Steve, did you get in broken or did ?was it working? I had one with low power, the circuit boards inside use metal standoffs, which loosen. Had to remove cover screws, one spun as the brass stand-off

Hello All, I recently acquired a used X5105., and so far have been unable to switch on and access any functions. -It will not switch on , no normal power up with or without external DC supply. -No

I want to use N1MM logging/contesting programme F keys to send CW.? I have a bespoke interface which connects the rig to a computer through the data port and the CAT socket, and it reads the radio

Im using? X108g192008-1-noneVOXDefault sound settings Im using a XGG.COMMS Interface with no supporting program, just WSJT-X Version 2.1.1 IIRC.No issues at all. Rig control works fine. Rick Sent

Hmmm!? The manual doesn't say.? I set my PC to 19,200 bps, 8n1 - if I remember right. And the X5105 uses Icom's CI-V serial communication protocol.? Setting the rig as an IC-7100 works (for many

how do I set the baud rate on the X5105?

so the X5105 has is rig control able? what are the interface connections you are using?

I have also run a USB sound card dongle but I have to run a TRRS cable from that to a now unavailable interface & homebrew connector to the non-Yaesu standard Xiegu data jack. Works fine on FT8.

can you share a picture of your preferances on the software. did you need to download any special drivers

Im using Xiegu X-108 as the rig selection with WIN 10 and EGGCOMMS interface. All functions including rig control are normal. Rick Sent from the all new AOL app for Android On Sat, Jul 16, 2022

I never pursued using data with this rig, but now I am ready to try as I have just started playing around with FT8 on my Yaesue FT991A. I use a Mac and the data software I'm using is WSJT-x. so I