开云体育

Great find! Thank you very much for posting the schematics. -------- Doug, K8RFT

Very good, okey

Interesting topic for the X5105. I was not thrilled with the X5105 speaker and decided to DIY and built a custom, active stereo audio amp for this radio and other QRP radios equipped with a low-level

And, not too long ago, I bought a little "Ki" rechargeable powered speaker to use with the X5105.? It does give a volume boost!? I have not yet used the speaker "on the air" yet, though. It is

Xiegu X 5105 Servis K?lavuzunu nerede bulabilirim?

Yes, I have used a small, un-amplified speaker intended for use with a PC.? It did help 'some' to make the audio clearer. -------- Doug, K8RFT

I can't answer your question directly, just add a bit of background.? First off, I prefer headphones, and have not tried using any sort of external speaker, either powered or 'plain.'? The headphone

Sorry, I wasn't correct or complete there - that's my total QSOs, using all 3 radios (first IC-706MkII at 12 watts, then X5105 and 2 watts, and for the last 2 years an FTdx10 at 10 watts. Most of the

Here's an update from Xiegu. Out of desperation I sent an email to Xiegu's support email rather than my direct contact I was supplied by an ex vendor as I never got a reply by the direct although

Hello everyone, Is the title says can the 5105 use an external unamplified speaker? Also in menu number 6 there is a button that is marked s/p. You push the button and it goes between speaker and

I use 1 watt and just find.

You've had really great results with 5W output!? Maybe try 'how low can you go?'? Try 1W?? 500mW?? I think this rig will 'turn down' to 100mW, too. 73 & have FUN!! Dan

AND you get 2.5 times as many "ego" points (or bragging rights) for using 2 watts instead of 5 watts. -------- Doug, K8RFT

Thank you Doug. I will follow your? suggestion. (2 watts)? Better to be safe . No repair is possible with X5105. Thank you? Dan. Yes , you're also right.? I thought that 5 watts was already a low

Isn't 'good amateur radio practice' to use the minimum power level to communicate? And, I'll agree with the 'turn it down a bit' so not to fry the radio. 73 & have fun radio-ing. Dan

Due to the relatively high duty cycle of FT8, I run my X5105 set for 2 watts output. I feel that it's better to be safe than sorry.? Especially with the lack of repair support from Xiegu. (I have my

Hi Lou, thank you for your kind answer and suggestion. I 'm using? ?FT8 for approx 1 hour? sessions with battery and/or with AC (without charging the battery at the same time) and I was surprised

Hi Bruno, I checked 2 different X5105 manuals and found the following: No mention of FT8 mode usage. Only reduced power on AM mode (see below). When using CW mode at a high duty

Hello I started to use X5105? in FT8 and? I am very happy .? Everything is working fine.? But now a doubt came in my mind. It's ok to use full power? of? X5105? (5 Watts) ? Or i should have to

Yeah, when you remove the end cap do it very gingerly because there are springs in there that lock the stand in the open position.? Examine how that lock piece is pushed into the notch in the stand