Re: IF Output and power

peter baker

Question with the IF output set to ON,? and using the output for a panadapter does the IF switch off and back on? when the PTT is push/released?

Re: IF Output and power

#778

On Sun, Dec 12, 2021 at 07:36 AM, @rycolos wrote:

default IF Output to ON

There's? a setting in the Main Menu to turn the I.F. output on and off.
?
--
Doug, K8RFT

Re: IF Output and power

#777

"
I checked my unit and IF Output is Off. Power cycling the radio does not enable it."

There's a setting in the Main Menu to turn it on and off.
--
Doug, K8RFT

Re: IF Output and power

#776

Greetings:? Could you tell me where a person can buy a malachite sdr receiver as shown on this email?? Thanks? Larry Hamre? AI9N

Show quoted text

On Tue, Jan 18, 2022 at 8:24 AM peter baker <peterbaker11@...> wrote:

I found this vide helpful??

Re: IF Output and power

peter baker

#775

I found this vide helpful??

Re: Signalink cable #signalink, #data cable #data

#774

In the link above the diagram of the rj45, now I include the part of the X5105.

Hope that works

César CA7OKD

CA7OKD

Re: Signalink cable #signalink, #data cable #data

#773

On Tue, Jan 11, 2022 at 02:37 PM, peter baker wrote:

SLCAB8PM

?or

Signalink cable #signalink, #data cable #data

peter baker

#772

Finding a signalink cable (SLCAB8PM) in the UK at the right price is like finding blood in a stone.
So we are going to have to make one!
Does about body have the wiring diagram for 8pin mini to rj45?

Re: speaker on while charging

#771

Good point, IronmanSubi?
Maybe the problem noise is actually, physically coming from the charger.? My system is completely quiet when turned off but charging.? Some power supplies (chargers) do make noise of their own, but usually it is just humming, not white noise.
--
Doug, K8RFT

Re: speaker on while charging

IronmanSubie

#770
Edited

White noise or hums is normally an indication of a rectifier or capacitor issue with the power supply. ?Does the white noise change at all the longer the unit is charging. I can’t see the Xiegu circuitry being the issue i feel it is simply responding to inadequate power supply or possibly the connection when the charge wire was assembled.

Re: speaker on while charging

peter baker

#769

开云体育

Charging voltage I've been using is 13.8, have also charged it from another battery 12.3 volt and always get the white noise from the speaker.

On 06/01/2022 23:51, IronmanSubie via groups.io wrote:

Show quoted text

[Edited Message Follows]
My radio is dead quiet when charging. What kind of charger are you using and what voltage?

Re: speaker on while charging

IronmanSubie

#768

I use a Jetstream JTPS30LCD 30amp power supply set to 13.7v and as mentioned the x5105 is quiet as it should. Maybe check as well what you have it near when charging, maybe change its location and see if anything changes. Honestly and I’m no electrical expert but that type of feedback isn’t consistent with any device being charged.?

Re: speaker on while charging

Joe K9SZ

#767

开云体育

I also hear a white noise when charging and thought it was typical behavior. I think the noise is possibly there when operating, too.

As a work around, I inserted one of the provided stereo plugs as a dummy into the speaker output to silent it. Since I operate primarily at my desk using FT8 with a headless Raspberry Pi, not hearing the audio doesn’t affect me. So, I ended up just leaving it inserted.

It is encouraging that others are not having this same issue. I’ll take a look at my power supply output soon.

73 Joe K9SZ

Show quoted text

On Jan 7, 2022, at 6:38 AM, Michael Sonnenblick <michael.sonnenblick@...> wrote:

I use a 13.5v charger (branded "Belker").

On Thu, Jan 6, 2022 at 6:52 PM IronmanSubie via <Ironmansubie=[email protected]> wrote:
[Edited Message Follows]
My radio is dead quiet when charging. What kind of charger are you using and what voltage?

Re: speaker on while charging

#766

I use a 13.5v charger (branded "Belker").

Show quoted text

On Thu, Jan 6, 2022 at 6:52 PM IronmanSubie via <Ironmansubie=[email protected]> wrote:

[Edited Message Follows]
My radio is dead quiet when charging. What kind of charger are you using and what voltage?

Re: speaker on while charging

#765

Mine is completely silent while charging on 13.8V power supply.

Re: X5105 - V3 Build 8 - WIP ?

#764

will there be a v3 ?

Re: speaker on while charging

IronmanSubie

#763
Edited

My radio is dead quiet when charging. What kind of charger are you using and what voltage?

Re: speaker on while charging

#762

I hear a white noise sound also when I am charging my radio.

speaker on while charging

peter baker

#761

Noted that while charging the speaker is on!. It sounds like the rig is receiving. No station just a background noise.
Is this normal??

X5105 - V3 Build 8 - WIP ?

#760

Is there a definitive list of X5105 V3.00 Build 8 firmware known issues and feature omissions ?

Much hype about the 6100 I fear is distracting Xiegu from finishing the radio I bought preventing users from getting the most out of their original investment.?

Reinstatement of the CTCSS capability for repeater access (also not available within 6100 ??) would be one for the list along with single button Message launch for differing messages (like the original RE1,RE2 & RE3 feature).?

Brian
2W0OXE