开云体育

Norman since you have the battery out, can you tell me is the battery made up of individual cells if so how many are in the pack or Is the battery a sack like an iPhone battery? ?If it is made up of

Thank you Kevin for your? suggestion. No, I don't have other terminal software as long as I remember on the main PC. I've tested the cable? on 4? different PC with the same? result. But on all 4

Thank you Jim for the explanation. As soon as I have the board I will try .? In the meantime , after my? complaint? with Xiegu Europe, they are shipping me for free another "original" cable. I'm

Hi Bruno Look at things this way: The X5105 is awaiting a signal on its RXD pin, so the Elektor will send a signal via its TXD pin. If the X5105 acknowledges a command it will send a signal to its

Hi Bruno, Do you have any braille terminal software running on your computer?? I had a program named brltty that was disabling the FTDI chip. Kevin W2NC

Hi Jim, just to be sure that I've well understood. RXD,TXD,GND marks? on the board? are printed on the edge . Good.? ?Instead for? X5105? should I consider what is? shown in the instruction

Agreed Doug however that 9vdc is what the battery monitor reports. That doesnt mean the battery is actually at 9vdc at the time. Thats the reason I believe the battery monitor is wacky on this rig. In

That sounds like it's better than one might expect.? 9 V. is a *lot* lower than 12.? I've been an electronics technician and repair man for about 50 years, and shutting down at 9 V. sounds

Yes, charging rate is very slow. -------- Doug, K8RFT

Ok Lou tnx. I dont know what to think at this point. The radio works fine until the battery gets down to around 9vdc and then it shuts down. It takes quite a few hours of on time before it gets to

Hi Rick, For the times I’ve used in on internal battery only, it goes to about 13.0VDC on a full charge and I recharge it at about 11.5VDC. Fairly wide range with no variation in performance.

Tnx Nick.Im starting to think that same thing but just wanted a confirmation. Regards,Rick Sent from my POS LG phone. Real radios glow in the dark. On Fri, Jul 28, 2023 at 14:27, Nick

I may be wrong but seems like someone determined that the battery voltage readout in the radio is in error. Nick Marsh WB4SQI Sent from an electronic device with a mind of its own.

I have a question about charging voltage on a X5105. Mine when on the charger reads 13.9vdc input. But after 12-24 hours charging the battery voltage reads 11.9vdc and never gets any higher. It has

Thank you david for your interest in my? "trouble". The problem is that I didn't have tthe cable that came with the radio. I bought it second hand the owner told me that there was no cable. For this

Many thanks? Jim . I really appreciate. Clear explanation. I? will buy the board. It could be? always useful for something else. I' ll let you know? . Bruno

Bruno, Try this: Remove the end cap that exposes the battery connection. IIRC, it is the one with the BNC connector. Unplug the battery from the circuit board. Try the update again using external

Hi Bruno The Elektor board is the same as the Xiegu cable in principle but requires a little work to hook up to the Xiegu X-5105 The COM port on the radio has three connections which are RX, TX, and

Thank you both for the reply, I have set the menu option for charging to OFF, Lou, you basically confirmed how I thought it worked, I am 100% sure mine used to switch off when the external power was

I looked at the replacement battery pictured on the EU sites. ?The battery has Chinese writing. ?So I translated it. ?According to the battery pictures it is a lithium battery. ?The battery also