开云体育

How are you linking PinPoint to VARA??? Note that VARA doesn't support traditional serial com port connections (real or virtual) like the KAM d

Has anybody been successful running Pin Point APRS on Vara HF? I can use a Kantronics Kam XL ,with Pin Point, and send a position report to my 30M AX25 packet receiving station ok. So, I know Pin

This is using Linux (Raspberry PI OS) with wine and Vara HF 4.8.9 and also 4.8.7: This was working, and then it just suddenly stopped working.? Every time I attempt to connect via PAT, it does not

If you have a PreAmp turned on for the lower bands, turn it Off. If you can't reduce the noise, you may consider using Attenuation on the lower bands. GL. Jim W7JWT

Ok, I wrote too quickly, the first time.? After pressing "send", I realized I should look at the AGC more closely.? The AGC had actually gotten disabled.? So, I enabled it, and tweaked it and the

Thanks for the idea, but the AGC is sitting just above minimum. I woke up last night, and realized my problem must be noisier bands on the lower frequencies. So, I turned on the speakers this morning,

The Winlink Express in a VARA HF session mode has an Auto-connect feature that is great for finding a workable frequency.? ? ?Within the VARA HF session window Settings, you can modify the

What is your AGC doing , <fridaymanyfeathers@...> wrote:

Looks like I finally have WinLink working…HOWEVER….despite trying several times and switching to other contacts I have yet to find one that’s not busy. Is that a common experience! Looking

Hi.? There's probably a simple explanation/fix, to make me feel stupid, but I'm having some trouble with my Winlink gateway. As it scans from 80m, 40m, 30m, 20m, 17m, the audio input jumps from deep

Wes I'm guessing the K5RAV gateway got updated to the latest beta of Trimode. I connected to it yesterday morning and had a 3000+ bps transmit rate while sending a Winlink check in. I would consider

There was a Winlink Trimode update early in the week. It appeared to be buggy & another update was released. The bug would cause the gateway to 'hang' at the point you indicated. Some, if not most,

Actually, being HF-radio-based, it is guaranteed that there will be down times due to varying solar activity (which affects the ionosphere's ability to bend radio waves beyond the horizon) - not

Thanks for the responses.? The problem cleared up as quickly as it came on...? I suppose I should have waited a few more days.? I like to think of 40M VARA are completely reliable, but, being

Thanks Don. Didn’t notice that 94 was omitted. Done now. Will work on it again tomorrow. Learning a lot! Sent: November 16, 2024 6:08 PM To: [email protected] Subject: Re: [VARA-MODEM] Problems -

I don't see WSPR as much of problem with VARA though VARA will likely wipe a WSPR signal.? IMHO VARA should move since First Come First Serve or Early Bird Gets the Worm prevails.? Respectfully,

Gerry, Study the FCC Part 97:221 a-c carefully. Automatically Controlled Digital Stations? with occupied bandwidth greater than 500 Hz must be in the defined ACDS sub-bands. Automatically Controlled

Keith You forgot to add the CIV. 94 is the number unless it is changed in the set>connector CIV settings 73 *Don PoapsNew Westminster, BC*VA7DGP DATA VA7QU VOICE *Winlink: va7dgp@...

Yes….then it wouldn’t do anything. Deselected it and back on it came.

Dave, Why do you say that the frequency is too low for unattended use. I am planning to setup a Trimode station that runs VARA/HF on 80 meters during the daylight hours. 73, gerry KK7GAB