开云体育

Yigal M. Rechtman via groups.io <Rechtman@...> wrote: You don't do channel selection in VARA. That is done in Winlink Express or any other application that does Winlink. (I suspect you

Hello, I moved temporarily to a new grid block. How do I change it so my channel selection is based on the new grid block? thank you, -- Yigal Rechtman /K2EFG

I never said you could use VARA on KAM. All I mentioned was what are modes typically used on VHF FM.

Theoretically yes.? In practice, no? The KAMs are radio modems intended primarily to be used in a command-line mode from an ASCII terminal or terminal app on a computer. You switch from the VHF to

I'm not sure about the other modes, but Pactor (or Pactor 1) seems to be supported by very few HF gateways. Those might be gateways that are still using older versions of Trimode... IDK, but I vaguely

Are any of the modes that the KAM+ are capable of even still in use anymore? I was planning to use it on both HF and VHF packet since it has the two ports, I wouldn't have to swap connections back and

1) May I try out mobile 40m VARA APRS on your West coast network? 2) APRS client is Pinpoint APRS. If you folks do not mind me trying this out on the West coast network, what beaconing interval would

That's strange that you can't join the group. The last email I got from that forum was January 11, 2025. Were you going to use the KAM + for anything other than packet? With the soundcard interface

Understood Scott Thanks very much Mike ?VA1KMA

Why even bother with the archaic hardware TNC?? Use the soundcard interface for everything!? I have done extensive controlled tests of hardware vs soundcard "soft TNCs" like the "UZ7HO Soundmodem"

Will Varadroid still interface with Backcountry Navigator, and do you all run a headless pc for VARA? TIA, David

I keep trying to join that forum, and it must be abandoned by the admins. I'll have to check and see whether I'm already on software carrier detect, I may be. The advice to use 9600 line I will take.

Since it seems to work ok with the squelch open, wouldn't it be better to set CD to SOFTWARE and leave the squelch open? I have my packet gateway's KPC3+ CD set to INTERNAL with the squelch closed and

And by the way, most of us run open squelch all the time on packet, and I haven't connected the squelch line to a TNC in years (actually decades). If your TNC does not do a good job of DCD on open

Keep in mind, if you run two instances of Winlink Express on different computers, they will have separate message databases. They will not be sync'ed, so you will see different messages on each

If your account has expired and been deleted, then there is no need to delete the existing account. If you get an error, then your account is still in the database, and what you need is the current

Thanks to all of you for your kind and informative replies. Now that I know that it can be done, it’s pretty obvious that the problem is me (operator error). I will give it another go over the next

You may wish to cross-post this question to the WinLink Programs Group: /g/Winlink several of the WinLink administrators monitor that group. 73, Ken NB6S

Hello! My winlink account from winlink.org expired and has been deleted obviously. How can I set up a new one? If I do as proposed, namely use the "winlink express application", it does not work

It definitely seems like the KAM+ doesn't appreciate the voltage rise on the RX line when the squelch opens when I leave squelch turned on. It only decodes if I leave squelch knob turned off. As for