开云体育

Thanks guys, I cannot believe that I missed the obvious!? Adjust the drive level right next to the tune button!? Geez I've been at the computer interfacing too many programs to my FT-891. 73, Terry

Lots of places to adjust transmit out level. But probably the best place so that it does not upset any other programs digital level in on the Vara HF modem program. Go to <settings><Soundcard> Hit the

I know this must be very obvious, but I cannot find the answer.? I have my FT-891 setup through a digirig to Winlink Express running Vara HF. When I press the Tune in Vara, the ALC is very high.?

Gateway question about using a single laptop / RMS Trimode / FT-991A / VARA HF. [As a reminder, the FT-991A has built-in sound card, rig control, and two antenna ports, HF & VHF] Can I configure RMS

Signalink feedback Greetings If you want to max out using signal link on VARA FM (highest speeds) / max band width make sure you have latest Signalink unit with surface mount 4Kc audio filters versus

It would depend on the radio. I've achieved 19000 bps on a Yaesu FT-2980 mono bander with a Signalink USB plugged into the microphone jack. It won't reach the maximum of 25210 but it will exceed

Any radio that uses the microphone connection for VARA will not do WIDE. I use the Repeater Builder dedicated interface on the Alinco, plugs into the 9 pin D-Sub on the back. Program the channel for

I've used Yaesu FTM-300DR and FTM-6000 with good results. Actually my old Icom IC-2720 which is on my VARA 2m gateway works just fine at 25210 bps, so any dual band with 9600 baud support should work

So what two radios are you talking about? ------------------------------------------------------------------------------- Stephen H. Smith??? wa8lmf (at) aol.com Skype:??????? WA8LMF

A question for the group before I purchase the above mentioned 2 mtr radio for VARAFm.is there any dual band uhf/vhf radio's that give the same performance? on both bands using VARAFM ??I know

Antenna Farm still has some of these in stock. Alinco DR-135T MkIII

Hello Mark, As it turns out the USB port on my PC is bad and the VARA log shows no contact with the sound card. It works fine on another PC. So at least I know that my settings are correct. Thank you

Is this just one day's attempts? Currently the conditions for 80 meters isn't all that great for day or night. Did you try any other bands? 73 John Denison KD5YOU

[email protected]> wrote:

I just finished testing this cabling. It worked for Winlink Tuesday and wednesday I adjusted system settings for the USB Microphone up from 50% to 75% to get FM VU meter up to about 1 o'clock. Cabling

I see that you have the digirig installed, but I didn't see if it was selected in VARA. Also, there are different versions of digirigs.? If you can't get the volumes right, you may have to modify it

Your RX audio looks a little bit high to me on VU meter try lowering it a bit see if it helps.

Hello Everyone. Wanted to thank you in advance for helping me out. Recently I have been using VARA FM a lot. Until I decided to check if VARA HF works. In the past it takes a while sometimes half an

Myrtle Beach [email protected]> wrote:

Re: " Our new local VARA node is up and running." Location? [email protected]> wrote: