开云体育

Matt, I have moved jumper. I think volume is the key. are you able to work VARA FM at 9600? I set the RMS to 9600 also, seems to work 1200 too. thanks loads. john

yes I got that, but still nothing. thanks

Mark, menu 601 is for the TNC, which we don't use with VARA FM, we use data port. which I thought was in 900 menu settings 919 but Ill try it thanks john

John; Menu 601 - DATA SPEED needs to be set to 9600 Mark - AD7EF

When you switch the radio from 1200 to 9600 the audio goes out a different pin in the back of the radio. Mat

John, I believe the Kenwood D710 is changed between 1200 and 9600 baud operation in the radios menu system (selected in software).? It's possible that 1200 or 9600 audio comes out the same pin on

I have a D710G.? A different pin is used for 1200 baud (narrow) vs 9600 baud (wide).? If you are using the din-6 adapter from Master Communications then you just need to move a jumper.? If you are

John, Describe the cable between your RA board and the Data Port on your D710. What wires have you connected on the DRA and D710, and to which data port on the D710 are you plugging

VARA FM works very fast at 1200... but has anyone set Ext 9600 using VARA FM? The only way we can get it to work so far is with EXT baud rate??set to 1200. Kenwood TM-D710g Menu 919 I have

I upgraded the cable from the radio to the Signalink to CAT 8 and in the spirit of overkill I added RFI suppression with an FT-240-43 torpid. I use the link on 6m FM. Charlie KM4ZZ

What cables did you upgrade to CAT 8, the Ethernet cabling?

Dang, now I'm going to need to get one of those.? The little adapter is a bit janky. Mat

I would get a DRA-36 (not on the website yet, but contact Kevin), and then use a cheap 6-pin to 6-pin PS/2 type cable from Amazon. Those cables are so cheap, just get another one and cut the connector

I would just use the DRA for everything. Unmodified, the Signalink is pretty ugly in the low end of the audio spectrum (do a google search on Signalink Mods). I rarely use mine for anything anymore.

Correct. I use a cheap ($5) PS/2 type cable from Amazon for the radio cable: -Scott, NS7C

Scott, Re the DRA-50… So you build one cable with both the 1200 and 9600 lines going thru and then jumper in the DRA as to what speed you want? Din 6 on each end… depending on the radio. Our

When using the "9600" pins on a radio you are connecting directly to the receiver discriminator (not bypassing it) and the transmitter modulator. It generally takes a lot more drive when you are

OK, I cranked up the volumes and that seemed to do the trick.? It is interesting the difference in volume levels between the two settings on the radio. Thanks again, Mat

Mat, In the VARA FM settings, Vara Setup, FM settings to Wide? Level all the way up on whatever channel (L or R) on the DRA30 you are using? Sound card RX level (L or R) up to at least 50%?

I have two DRA-30's with the DIN-6 Connector board attached to a Kenwood D710 and V71 for testing.? I have had good results testing VARA-FM in narrow mode with each radio having their data port