开云体育

You might try the programs API settings. I use the program but have not tried it yet with varac. Later today I will give it a try and let you know how it goes. Greg [email protected]> wrote:

Good morning. I am new to the group. Just started using VarAC and have a question. I normally use N3FJP logging software, however, I cannot get it to work with VarAC. Are there any users out there

I believe I found my answer already under the profiles settings. Ignore this for now. tnx

I've used VarAC on HF so I'm familiar with the ops. I'm working with a local group to use VarAC FM for EmComm support.? This is my first time setting up VarAC for FM/VHF.? I'm familiar with using

I recently obtained a Raspberry PI 5 as a gift from my wife. I have seen a lot of folks trying to get VARA and VARA FM running on a Raspberry PI. VARA and VARA FM and RMS Express are all Windows

Good evening. ?VaraC has gained popularity and growth. ?Please consider signing the following petition to encourage the ARRL to add support in LOTW. https://chng.it/SCb995cQMC

Yes , Where as Pactor uses all sorts of wonderfully [simple]modulation modes and has PAC as the? top ADIF listing, the MDGA [make data grate again] Us members? insisted DYNAMIC be used as the top

The last two advisories are irrelevant in this case. 1)? The setup is being used on a VHF/FM radio where you have no AGC controls. 2)? The soundcard interface connection is being made through a

Uncheck AGC in the windows sound settings. Set your transceiver's AGC setting to fast. Turn down the volume dial on your transceiver.

Yes, I am running the 9600 baud cable, and the high audio reading is when there is not a signal on the frequency. So, there may not be anything to be concerned with in this case since my system seems

Are you talking about the audio level when an actual signal is being received, or are you referring to the unsquelched white noise between transmissions???? Normally the no-signal white noise will

There is a way to reduce the audio from the radio to the PC. https://forum.digirig.net/t/ft-817-pc-audio-in-overload/3571 Basically you would cut the trace on the ATT pads inside the Digirig. I have

The Silicon Labs driver is for the serial port (only). It seems like you've got the incorrect audio device selected in the Soundcard settings in VARA HF. See

I’m running the VARA-FM Modem on a windows 10 machine with a DigiRig interface. The audio level shown in the VU meter hovers right at the Green/Red portion of the meter. I have the windows

Georges; Also, make sure you have "enhancements" turned off, on the transmit ("Payback" tab) of the Windows Sound control-panel, and that AGC is unchecked (if present) on the Rx ("Recording" tab) of

Georges; It may boil down to the T/R switching time in the crossover "machinery". On VARA FM, do you get responses for an "Auto Tune" test? That test isn't so dependent on the turn-around time. If

That one's gone down the memory hole now, but archive.org has a backup of it:

I just post in the varac forum.

Let me know as with several other apps that have an email notification capability. I think the two factor and password options have to be disengaged to make these email capabilities work. W4JDY /

As I understand it, v11 supports a one-way VMail relay through a true email client to an outside email address. An individual can set themselves up as a VMail relay station and should you connect to