I purchased two 150 watt scooter motors. I removed the front end cap and was planning to drill and tap a hole in the end cap to allow mounting of the Unimat motor bracket but found there is not enough material thickness in the area I need to place it. I want to reassemble the motor end cap and am having difficulty inserting the long screws do to having to struggle past the strong permanent magnet. Does anyone know a good trick to get past the magnets so I can screw the motor housing back together?
Dick
--
http://www.homemadetools.net/forum/?OFF-SET-tailstock-center-65965#post105972
?SMALL TURRET TOOL POST PLANS?
?LARGE TURRET TOOL POST PLANS
?MINI-LATHE CARRIAGE LOCK PLANS
?SMALL QC TOOL POST PLANS?
?QUICK CHANGE LATHE TURRET
?MINI LATHE COMPOUND PIVOT MODIFICATION
OldToolmaker