开云体育

All from memory, but I think this behavior will occur when you have the map set to center on your station. There would be cross hairs at your location if that is the case. But the cross hairs may be

I have PM9 installed, and within UI-view, if I am stopped or going slow - the map will zoom in automatically. I recall a long time back, this never happened. I did go into PM9 itself and adjusted the

Stephen, That's fantastic. I've been using PM9 in that fashion for several computers. What I'd like to see redeveloped is the weather radar on/over/in UI-View32. There was a "fix" someone posted but

That is great news. Thanks for the update. Dave W4VOR

Precision Mapping 9.0 in conjunction with the "Precision Mapping Server 9.0" plugin for UIview32 has been the preferred Mapping solution for North American users of UIview. It provides a seamless?

Hyperterminal was a basic ASCII terminal program bundled with versions of Window up to Windows XP.? A more advanced version was available for free download from it's publisher, Hilgraeve, until a few

Hi Joe, I am not that familiar with hypoterminal, unless by that you mean the terminal window in Uiview32, if that’s the case then you will not get a cmd prompt if you have the host mode set to KISS

Joe, I had the same issue with UIView when I upgraded to a windows 10 computer. Interestingly I have another program running on the same computer that also uses serial interface for my weather

If not you can always go back to basics... Make sure there is no flow control enabled!! Unplug the serial device. Make sure you have no activity on the screen when you type. Short pins 2 and 3 on the

Joe KC0NOX wrote... That is good. There shouldn't be any need to reinstall. Do you have any other serial devices you could connect, e.g. another TNC, a GPS receiver or whatever? Once you have verified

Bill, See below, in color. Seems to be in the computer to radio connection, based on my HyperTerminal fail. Not sure how to proceed from here. Thanks, Joe ---In ui-view@...,

Keith, Thank you. It is in C:/Peak Systems/UI-View. This was a setup from an area APRS group, but not in Program Files. I can certainly re-install. With hyperterminal, I am in Packet mode at 1200,

Hi Joe, I can tell you that Uiview and your d700 should work just fine with windows 10, mine does with no problems. Make sure you use the usb adapter with FTDI as that is generally the only one that

Joe KC0NOX wrote... On anything newer than XP, Windows uses UAC... user access control. Where do you have UI-View installed? Is it somewhere other than below "program files"? Yes, you can mess around

Ok, I'm at my wits end. I've been running UI-View on my Windows XP laptop which finally died. The backup, which had run UI-View on Windows 7 w/o issue was upgraded to Windows 10. Now I can't connect

This message is sent to all new members, and to all members every now and then. It has been revised as bounce reports have changed a bit. Any of us could experience no longer receiving email from the

The UI-View Group is very active. Most already do so, but here are some some guidelines to follow. 1. Civility... this is practiced well by our members! 2. Sign your messages with your name and

The UI-View Group is very active. Most already do so, but here are some some guidelines to follow. 1. Civility... this is practiced well by our members! 2. Sign your messages with your name and

This message is sent to all new members, and to all members every now and then. It has been revised as bounce reports have changed a bit. Any of us could experience no longer receiving email from the

Hi Bob (as per thread) My domain name has changed from www.apritch.myby.co.uk to www.apritch.co.uk (i.e. drop the dead .myby) Andy, M0CYP - Telford http://www.apritch.co.uk/uiview.htm