Using the TH-D74 with UI-View is supported by very specific instructions in the D74 manual. It appears there are clues as you proceed through the setup to watch for correct responses.
Did you follow the directions and see the proper responses as you did so?
Also, if your radio is operating on the APRS frequency without anything connected, can you hear valid packet noises when you listen to the audio with the squelch open?
Mike
------------------------------------------------------
toggle quoted message
Show quoted text
On 12/23/2021 10:36 AM, kk6cqx@... wrote:
Trying unsuccessfully to connect my Kenwood TH-D74 via Bluetooth to UI-View on a windows machine.
The radio is connected via bluetooth to the laptop. I can use other applications fine
In UI-View I am configured as follows
BaudRate 9600
Parity None
Com Port 5 (confirmed)
Data Bit 8
Stop Bit 1
Host Mode Kiss
Setup of HostMode I am using TNC2
- This is where I'm unsure of what to do.
My callsign is configured. I'm just not seeing any other data coming into UI-View
