Hi Bob
First make sure your network works using windows so you can access files on
the other computer.
Then install AGW (new version) on both machines
On the packet machine make sure winsock interface is ticked
run ui-view on the packet machine and make sure it works with agw.
run ui-view on the remote machine and setup the host to agw and clck on
setup and enter the IP address on the packet machine.
Once this is done you get UI-View on the remote machine operating exactly as
if it was on the packet machine. Nice one Roger!
====
If you wish to setup it up so as to connect to the internet from your packet
machine then you need to get hold of wingate and install it on your internet
machine.
Good Luck- Andy, G7OCW
toggle quoted message
Show quoted text
----- Original Message -----
From: Bob <g7paf@...>
To: <ui-view@...>
Sent: Friday, December 31, 1999 12:39 AM
Subject: [ui-view] lan feature !!!
well I have sat here for the past 3 hours and tried to get my packet
machine to work with my internet machine over the LAN
being a newbie to LAN I still need to do a bit of soul searching.
I have read the docs and still it eludes me
what exactly do I need to do ????
can someone enlighten me in layman's terms
I have for my internet machine a p133 with a pci network card running into
a 5 port hub
for packet I have a p300 with the same type of network card running into
the same hub
UI-view 2.16 is loaded onto both machines
I have seen the lights on the hub flashing (port 1 and 2) which leads me
to believe that I am most of the way there but I am missing that vital
ingredient !!!!!!!!!!!!!!!!!!!
ho hum
BTW Roger thanks for the f8 key on disabling the GPS makes driving a lot
easier now that I can switch to another application while on the move
Regards
Bob Scaife using ui-view 2.16 reg
g7paf@...
ax25 g7paf@gb7jem.#19.gbr.eu
icq 17945619
[Attachments have been removed from this message]
