开云体育

THANK YOU, John!!! Looks like I must have been successful AFTER all!!! :-) Now I just need to tweak it a little bit for best efficiency. I sincerely appreciate the feedback. Dave S. of

You're digipeater is working! See the attached Screenshot. John Emig W6GC 661-599-8689

Hello all .......I have a manufacturer-built model of a Byonics TT4A that had previously been successfully used ONLY as a mobile unit, for vehicle position reporting/tracking, and am now trying to set

I am interested in the MT 8000FA Contact direct at kb1chu@.... I'm good on QRZ Steve kb1chu

Hi everyone: I have an MT 8000 FA available if anyone can make use of it. I didn't find any information about it at the Byonics web site, but I did find this link to the manual: www.oe3pdb.radio ?

Well, there are 3 basic things:1. Make sure you have the TT4 connected properly (comercial cables to data jack or personal made cables??? Those connectors aren't very common.? Use pins 1,2,3, and

Hello everyone, I'm trying to send APRS messages using my PC connected to the TinyTrak4 which is connected to my FTM-100D radio. I set the Amode to TEXT and tried sending messages in APRS format but

BlueTooth under Linux is rather strange.Make sure you find the correct device.? The serial port connection usually has a designation of /dev/rfcomm#. You don't say what application you are running on

I don't know a thing about Fedors, but if your TT4BT and PC can connect, but there is no evidence of communication, I would verify that you have the Baud rates set correctly, i.e, both set to 19200,

I'm installing a mobile I-gate in my truck to fill-in in remote regions. Recently started using the TT4BT instead of 232-USB cable with my laptop.? Pairs and connects to my phone with APRSDroid.?

Thank you Allen. At the moment my TT3+ does all I need so I’ve no need to update. 73 Brian G8OSN www.g8osn.net ( http://www.g8osn.net )

You are fundamentally correct in all your assumptions about the TT3. You can't load a .t3f file into either a blank PIC, or a existing PIC 16F628 chip, since neither of these have the Byonics

Hi, This query is more to a matter of interest, at least at the moment, but I am confused. I have a TT3+ which uses a 16F628 PIC included in the kit. I note from the Byonics site, they have made

* Good Job * James KC0YEF

Yes it sounds too loud and distorted. Listen to other packets from nearby stations and lower your audio to match using the CALIBRATE and 1 or 2 keys. 73's Don

Robert, You have PPERIOD set to 0, it will never send a packet other than a startup packet. Try setting 120 ( Seconds) I suspect that is your root problem cause. When you say " It sounds completely

Yeah went through them did you watch YouTube video Thanks, Robert R Garcia (KF5VLZ)

Have you gone through the audios settings at: https://www.byonics.com/downloads/TinyTrak4%20Quick%20Start%20Guide%20v0.7.pdf TinyTrak4 Quick-Start Guide -

Hello, I am having an issue with my TinyTrak 4 in basic tracker config with GPS hooked up directly. It sounds completely wrong and not producing the data tone at all.... Please