开云体育

Hello, Dave and the group-- I'm not sure that we're recalling the same story, but some years ago I read a short story written in technical-report format about a couple of walkie-talkies delivered to

Hi Brian and Jim I am a bit embarrassed because I totally screwed up on some of the info I posted, I was at work and not in front of the unit so I was going by Memory. I looked at it today and on the

Have you checked with Artek Media for the manual ? 73, Dick, W1KSZ

Dennis, I believe the 7934 is the last 7000 series scope tha tTek intorduced. It also had the shortest life, and very well may be the shortest production run. I picked one up for a song, but with no

The 7854 can capture two waveforms at once. It stores them in two different waveform memory locations, and I believe doesn't display both of them unless told to. This is also how the 7854 acquires and

At page 6 top-right there is something I don't understand: " ... and since two waveforms can be digitized simultaneously, memory 1 was also set aside." According to the Op manual and to my experience

The 5116 was designed to work with the s/n B02XXXX and above 5D10s. I have a 5116 with a 5D10 and the left interface works like a charm. Older 511X oscilloscopes need to be modified for the left

Yes indeed, but the OP (and Arthur Clarke) got one of them wrong: Should read: "Any sufficiently advanced magic is indistinguishable from technology." I can't remember the exact context, but it

Whoa! Since your 2710 has the Option 14 VR module installed, you need to carefully consider whether you want to go forward with this modification. If you remove the Option 14 VR module assembly, you

This certainly gave me several chuckles. Sadly, it is all true. Michael

Hi Dennis. The SG5030 uses Torx as fasteners for e.g. the Rear Panel and the Interface Board. The same sort of Relais (148-0128-03/04) is used in the DP501. And yes mine uses Torx as fastener for

Hi Jim Thank you so much for the reply. I do have a VR BW board in that cavity and I received the TG with no cables at all, I will have to figure out how to obtain the needed parts and where to source

Thank you for the reply, it does have a module in that area so I would have to remove it to start things going. Wow this is going to be a lot more work than I thought, but it's nice to know that I

Go report me o the authorities sir

So you still didn't answer my original question and you still haven't addressed the issue of your smuggling merchandise into your country. As far as any crimes YOU commit -- that's your business, and

Egge Siert, I don't recall any TM500/5000 series using Torx at all. Tek uses Posi heads and hex set screws for knobs. Having said that, many HP products use Torx. The smallest Torx I have ever come

And of course there is O'Rielly's Law, which states: "Murphy is an optimist" D.

Ha! That was pretty funny! I too have forwarded that to others. Thanks for the laugh. ? Chris

Calm Down Jim. For a start YIG oscillators in this frequency range are not controlled items. For another, this is not a prohibited country in fact a partner in the WAT. The YIG and mixer ( actually a

Calm Down Jim. For a start YIG oscillators in this frequency range are not controlled items. For another, this is not a prohibited country in fact a partner in the WAT. The YIG and mixer ( actually a