开云体育

when looking at any signals between 85mhz and 110Mhz, the spec an won't lock on frequency (wont center). It will jump above and below the frequency and inidcate failure. Everywhere else in the

Sorry to jump in with questions on another person's original.I did change the subject line so to not dilute the original thread. I have not seen anyone suggest putting together a trigger

I think the TD is the problem. I got a similar problem in my 3B4 plugin. Try to detach one terminal of the TD CR566 (using adequate protection against heating, like a pliers) and check if the

Hi Stan, It's up to you and your wallet as to picking up a spare set of tunnel diodes. For me, it seems that parts 475 scopes are available at good prices. Since there are four TDs in each scope,

You need to find another post office. The clerks at some of the big, busy ones don't like it when you "waste" their time getting acceptance scans and a receipt, since you could just drop them in the

I used the same military manual from Bama. I had two reasons not to suggest that the tunnel diodes are the problem: 1. The common failure point for the symptoms does not implicate the tunnel diode

Well, at least I started diagnosing on the correct page this time. :) You could grow old thinking about all of the things that could go wrong with a 7T11. I have had problems with the board to board

Hello Tom, I will gladly avoid touching the tunnel diodes, and will start with David's suggestion. The only service manuals I have are from BAMA, which are the Army TM--- model manuals. Will these

Tymm Twillman <tymmothy@...> wrote: Hi Tymm -- Blast from the past - I ran br on Solaris for several years, until I gave up my last box w/ a serial interface. Search the group archives for fan

"Show me where I worked last and I'll show you where the problem is" When troubleshooting another problem, I had removed U500 (triggering) to look at it for some reason, and then didn't tighten down

"David C. Partridge" <david.partridge@...> wrote: Nice shooting! -ls-

The fault was in the Dot Position Memory circuit on the logic board, or more exactly the lack of a gate signal arriving at the base of Q650. Once I'd got that determined, removing and re-seating the

This is a follow-up to my repair of a 2232 scope with a bad CRT, part number 154-0861-10. I was able to find, for a very good price, a bad 2215A that seemed to have a good tube. It turns out that the

Molex makes some 0.063 Dia. pins & sockets for their connectors, that might help in building your own connector. Leon Robinson ?? K5JLR Political Correctness is a Political Disease.

They just didn't want you sending them chitlins, pork rinds, or pepperoni sausage. ? Or MREs containing SOS creamed chipped beef. ? Pareve, baby! ? 73 Jim N6OTQ

I'm not sure how this is handled in the US, but I think some of you may be talking about pickup at your home by the delivery guy and the confusion may result from this. I used to send PCBs to Israel.

hi, I also ship all over the world using postage from the ebay site. Once in a while their system will not scan the priority label until it gets delivered. When I ship priority mail international,

I would think that any country worldwide would require incoming international mail to have a customs declaration attached. I have received packages from many different countries and they all

I ship small packages internationally all the time, from various post offices. I have no idea what you're talking about; if you ship an international package (including first class), you have to have

It's unbelievable how much misinformation is in this thread. There's no requirement that packages over 13oz be handed to a clerk, IF you're using Priority or Express (International). You can print